IMPORTANT: Securely position the sanding disc on the disc assembly prior to applying power to the tool. AB C Fig. 9 Fig. 10 Fig. 11 ATTACHING DISC TABLE Fig. 12 A B C D D E E C A B Fig. 13ADISCONNECT MACHINE FROM POWER SOURCE. 1. Thread the disc table trunnion stud (A) Fig. 12 into the hole (B) on the side of the machine and tighten snug. 2. Place the disc table trunnion clamp (C) on the stud and insert the two pins (D) in the two holes (E). 3. Attach the washer, spring, and knob (Inset - Fig. 1

33 for use with a dust collection system. You must adjust the shield to suit your sanding operation. 1. If you are sanding with the disc, push in on the dust shield (A) Fig. 33. A Fig. 33 14 2. If you are sanding with the belt, pull the dust shield (A) Fig. 34 outward. A Fig. 34 WRENCH STORAGE A hole is provided in the stand for storing the hex wrench (A) Fig. 35, supplied with the sander. REMOVING UPPER SANDING A Fig. 35 DRUM GUARD You can remove the upper sanding drum guard (A) Fig. 36 to sand

To adjust the angle, slightly loosen the Lock Screw (15). (See Figure H.) 4. Observe the gauge on the Angle Plate (14). Raise or lower the Work Table (13) to set the Work Table to the desired angle. Then, retighten the Lock Screw (15) to lock the Work Table in place. (See Figure H.) SKU 05154 PAGE 12 FIGURE H LOCK SCREW (15) WORK TABLE (13) ANGLE PLATE (14) To AdjustThe Angle OfThe Miter Guide: 1. The angle of the Miter Guide (21) may be adjusted to the right 0 to 45 degrees and to the left 0 to

Part Number Description {Qty} F/C 1 2 605 104 549 Motor Housing 71 51 1 900 301 018 Bushing {2} 37 2 2 604 220 479 Field 120V 22 52 1 605 807 013 Pulley Fork 62 3/60 2 606 610 049 Fan 23 53 1 602 098 006 Belt Change Lever 64 4 2 607 200 385 Switch VS 1 54 1 604 619 017 Tension Spring 27 5 3 604 460 555 Cord 120V 18/2 11 55 2 917 030 710 Rivet 80 5/1 1 900 452 012 Terminal {2} 10 56 1 600 146 001 Lock Washer {2} 89 6 2 600 703 018 Strain Relief 11 59 2 601 098 037 Platten Plate 92 7 2 601 035 001