Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Table 1-1 Fibre Channel Driver Version History (continued)
Release
HP-UX 11.00
HP-UX 11i v1
HP-UX 11i v1.6
HP-UX 11i v2.0
HP-UX 11i v3.0
Web Release
B.11.31.0811 (64-bit)
0811
Application
B.11.11.18 (32-bit
B.11.23.0903
B.11.31.0903 (64-bit)
Release 0903
or 64-bit)
(64-bit)
Application
B.11.11.19 (32-bit
B.11.23.0909
B.11.31.0909 (64-bit)
Release 0909
or 64-bit)
(64-bit)
What is New in This Version
This version of the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver includes only defect fix
and does not offer any new features. For information about the defect fix, see “Defects Fixed in
This Release” (page 8).
Installation Requirements
You must install the following software and patch before installing the HP PCI Tachyon TL/TS/XL2
Fibre Channel driver on the system:
•
Fibre Channel Mass Storage (FCMS) Patch PHKL_23626 or later
This patch is available for download at the following websites:
http://h20293.www2.hp.com/
http://itresourcecenter.hp.com
Verifying the HP PCI Tachyon TL/TS/XL2 Fibre Channel Driver Installation
To verify whether the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver is installed successfully
on your system, enter the following command at the HP-UX prompt:
# swlist FibrChanl-00
Where:
FibrChanl-00
is the bundle name for the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver.
If the HP PCI Tachyon TL/TS/XL2 Fibre Channel driver is installed successfully on the system,
the following message is displayed:
# Initializing...
# Contacting target "hostname"...
#
# Target: hostname:/
#
# FibrChanl-00 B.11.11.19 PCI/HSC FibreChannel;Supptd HW=A6684A,A6685A,A5158A,A6795A
FibrChanl-00.FC-TACHYON-TL B.11.11.19 PCI/HSC FibreChannel;Supptd HW=A6684A,A6685A,A5158A,A6795A
Known Problems and Workarounds
Following are the known problems and workarounds in the HP PCI Tachyon TL/TS/XL2 Fibre
Channel driver:
•
Problem: During online replacement (OLR) of the A6795A adapter in Superdome systems,
the replacement can fail if the adapter is connected to the hub, switch, or device, and the
following error message is displayed:
OLARD error: General error
The slot is inaccessible till you power cycle the system.
What is New in This Version
7
...Эта инструкция также подходит к моделям:
Сетевое оборудование - HP-UX 11i v1 I/O Cards (204.84 kb)