Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
In this version of the iexgbe driver, FlexNICs are implemented; however, the bandwidth
allocation of each FlexNIC cannot be specified. This feature will be available in a future
release of the 10GigEthr-02 bundle.
This feature will be available in a future release of the 10GigEthr-02 bundle.
•
• Propagation of uplink status to Flex-NICs is not supported.
Severity: High
Version 11.31.0911 of the iexgbe driver does not support link state status when connected
to the HP BL-c VC Flex-10 Enet Module Opt (455880-B21). The link state of the uplink does
not propagate to the appropriate FlexNIC. Even if the uplink is in the “link down” state, the
FlexNIC driver reports a “link up” state as long as the connection to the interconnect module
is active. This functionality is required for Service Guard and LAN Monitor support.
Uplink status propagation will be supported in a future release of the 10GigEthr-02 bundle.
5 Compatibility and Installation Requirements
This section describes the compatibility information and installation requirements for this release.
•
For specific installation instructions, see the installation procedure or overview document
for your card.
•
For detailed information on supported server platforms, operating systems, and firmware
level requirements, see the Ethernet Support Matrix.
These documents are available at:
http://docs.hp.com/en/netcom.html
5.1 Operating System and Version Compatibility
This release is specific for HP-UX 11i v3 (B.11.31).
5.2 Hardware Requirements
This version of 10GigEthr-02 runs on HP Integrity BL860c (rev B) and BL870c server blades with
the HP-UX 11i v3 (B.11.31) operating system. This configuration has specific version requirements
for many system components. Table 1 summarizes these requirements:
Table 1 NC532m System Component Minimum Version Requirements
System component
Minimum version required
HP Integrity BL860c hardware revision
B
HP Integrity BL860c system firmware
4.21
HP Integrity BL870c system firmware
4.21
HP Onboard Administrator firmware
2.60
HP Virtual Connect firmware
2.30
467799-B21 HP BL-c NC532m NIC Adapter Opt Kit EFI driver
5.0.23
410916-B21 Cisco Catalyst Blade Switch 3020 Module firmware
12.2(50)SE
406740-B21 HP 1Gb Ethernet Pass-Thru Module firmware
2.8.3
6 Related Information
The latest documentation for Ethernet cards is available in English at:
http://docs.hp.com/en/netcom.html
4
...Эта инструкция также подходит к моделям:
Сетевое оборудование - HP-UX 11i v3 I/O Cards (241.57 kb)