Войти:
Оценок - 0, средний балл: 0 ( )

Инструкция по эксплуатации HP, модель HP 10 Gigabit Ethernet Cards

Производитель: HP
Размер: 162.41 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



К этому устройству также есть другие инструкции:

Фрагмент инструкции


4 Known problems and limitations
The following problems are known to exist in version B.11.31.1203:

Using ncweb to change number of receive queues causes an error message.
Severity: Medium
When you use the ncweb or SMH interface to change the number of receive queues, an error
message appears.
Workaround: Use nwmgr instead of ncweb to change number of the queues. The command
syntax is:
nwmgr -s -A drv_mq= -c lan
where

The number of queues that you want to enable.

Instance number of the LAN interface; for example, lan1.
5 Compatibility and installation requirements
This section describes the compatibility information and installation requirements for this release.

For specific installation instructions, see the installation procedure or overview document for
your card.

For detailed information on supported server platforms, operating systems, and firmware level
requirements, see the Ethernet Support Matrix.
These documents are available at:
http://www.hp.com/go/10-gigabit-ethernet-docs
5.1 Operating system and version compatibility
This release is specific for HP-UX 11i v3 (B.11.31).
5.2 Hardware requirements
This version of 10GigEthr-02 runs on HP Integrity servers with the HP-UX 11i v3 (B.11.31) operating
system. This configuration has specific version requirements for many system components:
Table 4 System component minimum version requirements
System component
Minimum version required
HP Integrity BL860c hardware revision
B
HP Integrity BL860c system firmware
4.21
HP Integrity BL870c system firmware
4.21
HP Integrity BL8x0c i2 system firmware
Use the latest system firmware. For
information on how to obtain and install
HP Integrity Superdome 2 system firmware
system firmware, see the server
documentation.
HP Onboard Administrator firmware
3.0
NC532m, AM225A, AM232A, AM233A EFI driver
5.2.27
HP Virtual Connect firmware
Use the latest version available. For
information on how to obtain and install
Interconnect module firmware
interconnect module firmware, see the
product's documentation.
4 Known problems and limitations
5


...

Эта инструкция также подходит к моделям:
Сетевое оборудование - HP-UX 11i v3 I/O Cards (162.41 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории