Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
Location:Orange, CA, USASignature: Date:February 22, 2006Full Name:Gregory P. SmithPosition:Director, Product Development Appendix: SAN Installation 58 8e6 Enterprise Reporter Quick Start Guide Appendix: SCSI Connected Storage Device This appendix pertains to the installation of the optional NAS (SCSI Connected Storage Device or “SAN”) unit. Preliminary Setup Procedures Unpack the Unit from the Carton Inspect the packaging container for evidence of mishandling during transit. If the packaging container is damaged, photograph it for reference. Carefully unpack the unit from the carton and verify that all accessories are included. Save all packing materials in the event that the unit needs to be returned to 8e6 Technologies. The carton should contain the following items: 1 Nexsan Technologies unit 1 Mounting Kit 1 Accessory Kit containing: 2 AC Power Cords 1 Ultra SCSI 160 cable Other Required Installation Items In addition to the contents of the Nexsan carton, you will need the following items to install the storage device: 1 Standard CAT-5E cable 1 CAT-5E crossover cable (from the ER server carton) Inspect the unit and accessories for damage. If the contents appear damaged, file a damage claim with the carrier immediately. NOTE: Refer to the ER safety precautions. In addition to being applicable to the ER, this information also applies to this storage device unit. Appendix: SAN Installation 8e6 Enterprise Reporter Quick Start Guide 59 Rack Mount the Server Rack Mount Components The following items are needed to install rails for rack mounting: 1 x Slide Kit and Mounting Hardware 1 pair Accuride Slide Rails Rack Setup Precautions Warning: Before rack mounting the unit, the physical environment should be set up to safely accommodate the unit. Be sure that: The weight of all units in the rack is evenly distributed. Hazardous conditions may be created by an uneven weight distribution. The rack will not tip over when the unit is mounted, even when the unit is fully extended from the rack. For a single rack installation, stabilizers are attached to the rack. For multiple rack installations, racks are coupled together. The rack is grounded and will maintain a reliable ground at all times. A power cord will be long enough to fit into the unit when properly mounted in the rack and will be able to supply power to the unit. The connection of the unit to the power supply will not overload any circuits. The unit is only connected to a properly rated supply circuit. Reliable earthing (grounding) of rack-mounted equipment should be maintained. The air flow through the unit’s fan or vents is not restricted. The maximum operating ambient temperature does not exceed 104°F (40°C). NOTE: Always make sure the rack is stable before extending a component from the rack. WARNING: Extend only one component at a time. Extending two or more components simultaneously may cause the rack to become unstable. Step 1 Remove inner slide rail as shown. Press down on latch to releas...
Эта инструкция также подходит к моделям:Сетевое оборудование - ER3-200 (5K02-56) (3.8 mb)
Сетевое оборудование - ER3-100 (5K02-55) (3.8 mb)
Сетевое оборудование - ER3-100 (5K02-55) (3.8 mb)
Сетевое оборудование - ER3-200 (5K02-56) (3.8 mb)