Оценок - 2, средний балл: 4
(
)
)
|
Фрагмент инструкции
Action 1: Check the cable connections. The sizes of the left half and the right half of the computer Cause 1: Cable not attached properly. Action 1: Check the cable connections. screen differ. Cause 2: The graphics card setting is incorrect. Action 2: Some graphics cards may require the video output setting changed, by using a software program associated with the graphics card. For details, refer to the user ’s manual for the graphics card. 13 P/N: 55P5776 The wrong display mode is displayed. Cause 1: The converter box is not connected to the proper connector of the graphics card. Action 1: Connect the converter box to the connector supporting DVI Dual Link output, referring to the instructions in Chapter 2. Cause 2: The monitor's EDID setting is incorrect. Action 2: Set the correct value for your graphics card, referring to the T221 Flat-Panel Monitor Users Guide. Restart the system after making any changes. Cause 3: You are using an unsupported graphics card, or the device driver is downlevel. Action 3: Check that the graphics card is a supported type and that the latest level device drivers are being used (see the T221 Flat-Panel Monitor Users Guide for further information & details on how to access the web support page). Cause 4: The graphics card setting is incorrect. Action 4: Some graphics cards may require the video output setting changed, by using a software program associated with the graphics card. For the detail, refer to the user ’s manual for the graphics card. The Color Management Utility Cause 1: The USB cable is connected to the connector B of the or the Firmware Update monitor. Utility does not work. Action 1: Disconnect the USB cable, and then connect the USB cable to the converter box that is connected to the connector A of the monitor. 14 P/N: 55P5776 Appendix A. Product Specifications The following table shows the converter box specifications. They only apply when the converter box is used with the IBM T221 monitor. Table 2 Product specifications Item Specification Outer dimensions (converter box housing) Width: 106.4 mm Height: 30.8 mm Depth: 107.6 mm Weight (converter box housing) 350 g Input voltage (supplied from monitor) 16 V Power consumption (maximum) 3.5 W (maximum) Video input DVI TM Dual Link interface Video output TMDS TM interface (RGB: 8bits each) Standards compliance AN/NZS 3548 CISPR22 A FCC-A IEC 60950 3rd. Ed. UL 60950 3rd. Ed. / CSA C22.2 No. 60950-00 VCCI-A ISO 13406-2 Temperature Operating Shipping (by air & within 24 hours) Storage / Shipping (other than above) 0 ~ 35 deg C -20 ~ 60 deg C 1 ~ 60 deg C Humidity Operating Shipping (by air & within 24 hours) Storage / Shipping (other than above) 8 ~ 80 % (No Condensation) 8 ~ 80 % (No Condensation) 8 ~ 80 % (No Condensation) 15 P/N: 55P5776 Appendix B. Regulatory Compliance Federal Communications Commission (FCC) Statement IBM Converter box (P/N: 07N2230, FRU P/N: 13M3200) This equipment has been tested and found to comply with the limits for a Class A digi...
Эта инструкция также подходит к моделям:Ресиверы и усилители - 07N2229 (532.75 kb)
Ресиверы и усилители - 13M3200 (532.75 kb)
Ресиверы и усилители - 07N2230 (532.75 kb)
Ресиверы и усилители - 55P5728 (532.75 kb)