Оценок - 1, средний балл: 5 ( )

Производитель: IBM Размер: 532.75 kb Название файла: Язык инструкции:

Note: The video input and video output are Safety Extra Low Voltage (SELV) circuits. 9 P/N: 55P5776 Fig. 9 Connection of the Dual Link signal cable and the converter box Connect the opposite end of the dual-link signal cable (55P5729) to the computer. If the computer graphics card has another connector that supports DVI Single Link out or Dual Link out in addition to the DVI Dual Link connector, connect the signal cable to the Dual Link connector. (The Dual Link connector is typically marked as "1" or "A". For details, see your graphics card manual or computer manual.) The USB cable (55P5728) must also be connected to the computer to enable use of monitor's Color Management Utility or Firmware Update Utility. USB cable (55P5728) Dual Link signal cable (55P5729) Fig. 11 Connection of the Dual Link signal cable and a graphics card 10 P/N: 55P5776 Important: If the connector is not properly inserted, the computer or graphics card may be damaged when you power on the computer. Insert the connector straight and firmly so as not to bend the connector pins. 2.3.Setup Replace the covers on the back of the monitor and return the monitor to the upright position. Plug the power cords of the monitor and computer into wall outlets. The power lamp on the converter box should come on steady green, indicating normal operation. (The power lamp on the converter box does not come on unless the monitor is connected to an AC power supply.) 3. Changing the Monitor EDID Setting Change the monitor's Extended Display Identification Data (EDID) setting to suit your particular graphics card. See the T221 Flat-Panel Monitor Users Guide for further information. This completes converter box installation and setup. 11 P/N: 55P5776 4. Troubleshooting This chapter explains what to do if a problem occurs while you are using the monitor. Only problems related to the converter box are covered here. Refer also to your monitor manual for troubleshooting information. Table 1 Problems and Actions Problem Cause and action Blank screen (LED lamp on the monitor is steady amber or blinking amber.) Cause 1: No power to the converter box. Action 1: Power on the monitor and make sure that the monitor power lamp is steady amber or blinking amber. Then look at the power lamp on the converter box (next to the connector for the converter signal cable (07N2229)). If the lamp did not come on, the converter box has no power supply. Re-connect the cable between converter box and monitor, referring to the instructions in Chapter 2 for installing the converter box. Be sure to use the cable supplied with the converter box. If the lamp is green, the converter box is properly powered on. A green light with a blank screen means that the digital signal is disconnected somewhere. Check all the digital signal cable connections, referring to the instructions in Chapter 2 for installing the converter box. Cause 2: The monitor's EDID setting is incorrect. Action 2: Set the correct value for your graphics card, r...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: