Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
15 5 P/N: 55P5776 P/N: 07N2229 P/N: 55P5776 P/N: 07N2229 Fig. 3 Converter signal cable (length 65cm approx.) Fig. 4 User’s guide (this book) P/N: 55P5729 Fig. 5 Dual Link signal cable (length 200cm approx.) Important: Do not use other cables for T221 and the converter box. Do not use these cables for other equipment than the T221 monitor and converter box. 2. Connecting the Converter Box See your monitor manual for instructions and precautions on handling the monitor. Important: Use a large desk or table covered with a soft, thick cloth if you need to lay the monitor face down during installation. Make sure there are no pencils, clips, or other hard objects under the monitor screen, and avoid knocking or bumping the monitor. Such treatment could damage the monitor. 2.1.Disconnecting the Existing Digital Signal Cable Power off both of the monitor and the computer. Unplug the AC power cords of the monitor and computer from the wall outlets. At the back of the monitor, remove the stand rear cover and connector cover, and disconnect the 7 P/N: 55P5776 digital signal cable. If two digital signal cables are attached, disconnect both. Disconnect the digital signal cable from the computer. The disconnected digital signal cable is unnecessary with a converter box. Store the cable away. Important: Connecting or disconnecting cables while the monitor or computer is switched on may damage the computer or graphics card. 2.2.Connecting the Converter Box Display Signal Cables Dual Link signal cable Converter signal cable Converter box Fig. 6 Dual Link Connect the end marked "A" of the converter signal cable (07N2229) to digital signal connector A at the rear of the monitor. 8 P/N: 55P5776 Converter signal cable (07N2229) Cable hook Cable clamp Fig. 7 Connection of the converter signal cable and the monitor Connect the other end (marked "3") of the converter signal cable (07N2229) to the converter box. Fig. 8 Connection of the converter signal cable and the converter box Connect the dual-link signal cable (55P5729) to the converter box. It is only necessary to connect the USB cable (55P5728) to the converter box if you wish to use the monitor's Color Management Utility or Firmware Update Utility. In this case, the program(s) for either or both of those utilities must be installed prior to connecting the USB cable. Important: Do not connect the USB cable unless you are using the Color Management Utility or Firmware Update Utility. Note: The video input and video output are Safety Extra Low Voltage (SELV) circuits. 9 P/N: 55P5776 Fig. 9 Connection of the Dual Link signal cable and the converter box Connect the opposite end of the dual-link signal cable (55P5729) to the computer. If the computer graphics card has another connector that supports DVI Single Link out or Dual Link out in addition to the DVI Dual Link connector, connect the signal cable to the Dual Link connector. (The Dual Link connector is typically marked as "1" or "A". For details, see your graphics...
Эта инструкция также подходит к моделям:Ресиверы и усилители - 07N2229 (532.75 kb)
Ресиверы и усилители - 13M3200 (532.75 kb)
Ресиверы и усилители - 55P5728 (532.75 kb)
Ресиверы и усилители - 55P5729 (532.75 kb)