Monito . OWNER. . MANUA . Model No . M- . Channels C- . Serial No . S- . Dear Customer . Please fill in the model and . serial numbers above fro . the label inside the batter . compartment of your ne . Nursery Monitor . Both Parent.s Unit an . Nursery Unit MUST be se . to the same channel fo . the system to operate . © 1998 Graco 900-5-9 . Please read this Owner. Manual completely . first use of your monitor! Pa . special attention to the warn . ings . Keep these instruction . for future referen

The green power light should come on. 6. Within a few seconds, the Parent Unit will lock on to the Nursery Unit and the top four (4) green LEDs will shut off. A second later, you will hear a series of beeps and the connection LED should change from red to green. Your monitor is now ready for use. 7. If the top four (4) LEDs do not shut off, power off the Parent Unit and the Nursery Unit and repeat steps 4 and 5 above. 8. If the connection LED on the Parent Unit does not change from red to green

The Parent Unit will operate if the rechargeable battery is charged. Selecting Channels • In case you are experiencing some interference, the channel on the Nursery Unit can be changed by pressing the “ch” button on the side of the unit. The Parent Unit will automatically scan all of the available channels until it locks on to the Nursery Unit. If you are still experiencing interference, press the channel button on the side of the Nursery Unit up to 6 times until a good channel is found. 3 Low B

• Do not attempt to recharge a non-rechargeable battery. • A rechargeable battery CANNOT be recharged by plugging the AC adapter into the Nursery Unit. • Remove the batteries from the unit if it is no longer being used or will be stored for an extended period of time. Battery Installation Using AC Adapters + - + -+ - Plug in cord Parent Unit • The battery must be plugged into the Parent Unit before the unit will be ready for use. Remove the battery door cover on the Parent Unit with a key or fla

Any modifications to the transmitter and/or receiver can void the operator’s authority to operate the equipment. • Power is turned ON for both units • Both units are plugged in (or battery is fresh in Parent’s Unit) • Electrical outlet works • Units are set to same channel • Volume is turned up on Parent’s Unit • Parent’s Unit is in range of the Nursery Unit Most problems have a simple solution. First, check that: • Parent’s Unit too far from Nursery Unit — move closer. • Large objects blocking

The short time you spend reading these instructions will help you use your nursery monitor properly. Cher client, Graco est le chef de file dans la conception et la fabrication de produits de qualite pour bebe. Nous croyons que le moniteur de nursery de Graco est un choix judicieux. Avant d’utiliser votre moniteur de nursery, prenez quelques minutes pour lire le manuel d’utilisateur. Ce court instant que vous prendrez a lire les instructions vous aidera a utiliser correctement votre moniteur de

3. Aim the Nursery Unit toward your baby. Check that there are no walls or large objects that could block sound transmission. 4. Turn on the Nursery Unit using the ON/OFF switch. The green power light should come on. 5. Install a 9 volt battery into the Parent’s Unit, or plug it into a working 120 volt AC outlet using the other AC adapter. 6. Turn on the Parent’s Unit using the volume control dial. The red power light should come on. • The Parent’s Unit can use either a 9 volt battery or standar

Ultraclear™ Moniteur Manuel d’utilisateur Veuiller garder pour usage ulterieur. Monitor Ultraclear™ Manual del propietario Por favor, conservelo para utilizarlo en el futuro. 2755 Dear Customer, Graco is the recognized leader in the design and manufacture of quality baby products. We believe your new Graco nursery monitor is a wise choice. Before using your nursery monitor, please take a few minutes to read this Owner’s Manual. The short time you spend reading these instructions will help you us

• Look for the FCC ID on the bottom of the Nursery Unit and inside the Battery compartment on the Parent Unit. Graco Children’s Products Simple Sounds 2L00 3 Glenlake Pkwy Atlanta, GA 30328 2 Parent Unit • Remove the battery door cover on the Parent Unit with a key or flat blade screw driver. • Place 3-AAA (1.5V-LR03) batteries into the battery compartment. Note the proper orientation of the batteries. • Do not mix old and new batteries. • Do not mix alkaline, standard (carbon zinc), or recharge

No user-serviceable parts inside. Risk of electrical shock, fire or death. 5 • Remove battery from Parent’s Unit if it will not be used for a long time. • Remove a dead battery promptly. A dead battery left in unit may leak, damaging your unit. • Do not attempt to recharge a non-rechargeable battery. • A rechargeable battery CANNOT be recharged by plugging AC adapter into the Parent’s Unit. Remove the battery from unit to recharge it. • Charging of a rechargeable battery should only be done by a