Оценок - 3, средний балл: 4.7
(
)
)
|
Фрагмент инструкции
TallyGenicom reserves the right to revise this manual without notice, for any reason. This includes, but is not limited to, utilization of advances in the state-of-the-art and changes in the equipment or configuration thereof. Liability for difficulties arising from unknown or unforeseen technical limitations is disclaimed. FCC Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15, Subpart B of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense. WARNING Only trained qualified personnel may open covers or remove parts that are not explicitly shown and described in the Operator’s Manual as being accessible to the operator. Please Note: Printer drivers for various operating systems are available on the Internet at our Web Page or or at your TallyGenicom distributor. ACKNOWLEDGMENTS: “IBM” and “Proprinter” are trademarks of International Business Machines Corporation. “Epson” is a trademark of Seiko Epson Corp. 2900 Series Operator Manual © October 2007 All rights reserved TallyGenicom 6020 South 190th Street Kent, Washington 98032 Operator Manual Contents Preface ......................................................................................................... 3–9 Introduction ............................................................................................................................... 3–9 About This Manual ................................................................................................................... 3–10 Chapter 1 .................................................................................................... 3–11 Site Preparation ........................................................................................................................ 3–11 Figure 1 - 1. Shipping Screw Locations ............................................................................ 3–12 Unpacking your printer ........................................................................................................... 3–12 Repacking ................................................................................................................................. 3–12 Removing the Shipping Hardware.......................................................................................... 3–12 Figure 1 - 3. Rear view, showing Serial, Parallel and Power Plugs .................................. 3–13 Connecting the I/O ................................................................................................................. 3–13 Interface Connections and Powering Up ............................................................................... 3–13 ................................................................................................................................................... 3–13 Interface Connectors ............................................................................................................... 3–13 Powering Up ............................................................................................................................. 3–14 Figure 1 - 4. Power plug and on/off switch ..................................................................... 3–14 Figure 1 - 5. Inside the Lid ................................................................................................ 3–15 Paper System ............................................................................................................................. 3–15 Paper System Components ...................................................................................................... 3–15 Print Gap ................................................................................................................................... 3–16 Paper Tension ........................................................................................................................... 3–16 Tractors ..................................................................................................................................... 3–16 Figure 1 - 6. Left and Right Paper Tractors ..................................................................... 3–16 Installing the Ribbon Cartridge .............................................................................................. 3–17 Figure 1 - 8. Installing the Ribbon Cartridge.......................................................