• Frame ground – Do not allow tools or other metal objects to contact frame when disconnecting batteries or other electrical wiring. Never allow a positive wire to touch the vehicle frame, engine, or other metal component. PERIODIC SERVICE SCHEDULES See General Warnings on page 10. y WARNING • Service, repairs, and adjustments must be made per instructions in the maintenance and service manual. NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, the preventi

6.2. Loosen, but do not remove, the carburetor drain screw and drain fuel remaining in bowl into a small, clean container, then pour the fuel from the container into vehicle fuel tank. Tighten the carburetor drain screw. 6.3. Fill fuel tank to about 1 inch (2.5 cm) from top of fuel tank and, following manufacturer’s directions, add a commercially available fuel stabilizer (such as Sta-Bil®). 6.4. Disconnect fuel vent line from fuel tank vent nipple. 6.5. Plug the fuel tank vent nipple so that it

No other warranties, express or implied, are contained herein. Please complete and return the warranty registration card included in this manual. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. This manual contains proprietary information that is protected by copyright. All rights are reserved. No part of this manual may be photocopied, reproduced, or translated to another language without the w

• Unload cargo bed before raising vehicle with a lift, hoist, or jack. • Avoid stopping on a hill when loaded. If you must stop on a hill, avoid sudden starts, or rollingbackwards and stopping suddenly. Failure to heed this warning may cause vehicle to overturn, possibly resulting in severe personal injury. WARNING CONTINUED ON NEXT PAGE... Page 22 2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual Vehicle Load Capacities y WARNING • Reduce speed and avoid sudden stops when backing up. Fai

8 Proposition 65 – State of California........................................................................................................................ 8 Safety Details....................................................................................................................................................... 9 General Warnings............................................................................................................................................... 10 General

If the vehicle is hard to start in cool or cold temperatures, simply push in the choke cover to activate it. Hold it during start up and release the choke cover after the engine starts and runs smoothly. 12 Figure 13 Choke Figure 14 Low Oil Warning Light and Headlight Switch LOW OIL WARNING LIGHT Gasoline Vehicles Only The gasoline golf car is equipped with a low oil warning light (1), located on the dash panel to the right of the key switch (Figure 14). If the warning light comes on, oil should

NOTE: If the vehicle is constantly subjected to heavy use or severe operating conditions, the preventive maintenance procedures should be performed more often than recommended in the Periodic Service and Lubrication Schedule. Both the Periodic Service Schedule and the Periodic Lubrication Schedule must be followed to keep vehicle in optimum operating condition. PERIODIC SERVICE SCHEDULE REGULAR INTERVAL SERVICE Daily service by owneror trained technician Engine Check engine oil level; add if nec

(98 cm) Weight (without batteries) 544 lb. (246 kg) Weight (dry, without battery) 669 lb. (303 kg) Forward speed 17 mph (27 km) Vehicle Specifications continued on next page... Page 46 2006 Husqvarna 4210-G, 4210-E, 4210-GXP, and 4210-EXP Owner’s Manual Vehicle Specifications SPECIFICATIONS Electric HUV4210-E Electric HUV4210EXP Gasoline HUV4210-G Gasoline HUV4210GXP Standard seating capacity 2 LIQUID CAPACITIES Transaxle 22 oz. (0.67 L) Engine crankcase (without filter) 32 oz. (0.95 L) Engine c

Never install tires of differentdiameters on the vehicle. • Reduced steering control can occur when the front differential is locked. STOPPING THE VEHICLE To stop the vehicle, release the accelerator pedal and press the brake pedal until the vehicle comes to a complete stop. See following WARNING and CAUTION. WARNING • Driving through water may affect the brakes. After driving through water, check effectiveness of thebrakes by gently pressing the brake pedal. If the vehicle does not slow down at

LUBRICATION CHANGE FOR FRONT DIFFERENTIAL, TRANSMISSION, AND REAR DIFFERENTIAL Use the lower plug (2) for drainage (Figure 30, Figure 31, or Figure 32). Remove both plugs to allow the lubricant to drain faster. See preceding NOTE. Metal particles may be discovered in the fluid or on the magnetic drain plug when changing the differential or transmission fluid. These particles are normal and expected for the first few fluid changes. This is a result of the gears being “net forged”, meaning the gea