Войти:
Оценок - 4, средний балл: 4 ( )

Инструкция по эксплуатации Husqvarna, модель HUV 4414-XP

Производитель: Husqvarna
Размер: 4.82 mb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Never install tires of differentdiameters on the vehicle. • Reduced steering control can occur when the front differential is locked. STOPPING THE VEHICLE To stop the vehicle, release the accelerator pedal and press the brake pedal until the vehicle comes to a complete stop. See following WARNING and CAUTION. WARNING • Driving through water may affect the brakes. After driving through water, check effectiveness of thebrakes by gently pressing the brake pedal. If the vehicle does not slow down at the normal rate, continue to press the brake pedal until the brakes dry out and normal performance returns. CAUTION • When stopped on a hill, use the brake pedal to hold your position. Do not use the accelerator pedalto hold position. 2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 23 Bed Latch PARKING AND LEAVING THE VEHICLE 1. After stopping the vehicle, firmly set the park brake. Make sure it is fully engaged. This will prevent the vehicle from rolling. 2. Turn the key switch to the OFF position, remove the key, and place the Forward/Reverse handle in the NEUTRAL position. BED LATCH See General Warnings on page 10. The bed latch (2) is located below the front lower corner of cargo bed on the driver’s side (Figure 8). To lift the bed, pull the bed latch handle upward to unlatch and lift the bed. Raise the bed to the full up position. To close the bed, gently lower the bed until the latch engages and secures the bed in the down, locked position. DO NOT drop the bed. See following DANGER and WARNING. DANGER • Use caution when working under bed. Be sure cargo bed is secure. Otherwise the bed will fall, resulting in severe personal injury or death. WARNING • Remove all cargo before raising the bed or servicing the vehicle. Ensure that cargo bed is secure inthe full upright position. Do not close bed until all persons are clear of cargo bed area. Keep handsclear of all crush areas. Do not drop cargo bed; lower gently and keep entire body clear. Failure toheed this warning could result in severe personal injury or death. 2 Figure 8 Bed Latch Page 24 2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Bed Locking Pin BED LOCKING PIN See General Warnings on page 10. While holding the bed in the fully raised position, remove the bed locking pin from its stowed position under the bed and insert it into the bed locking pin holes in the bed hinge plates (Figure 9, Page 25). Prior to lowering the bed, remove the bed locking pin from the bed locking pin holes in the bed hinge plates and return it to its stowed position under the bed. See following DANGER and WARNING. DANGER • Use caution when working under bed. Be sure bed is secured with locking pin. Otherwise the bedcould fall, resulting in severe personal injury or death. WARNING • For vehicles with cargo beds, remove all cargo before raising the bed or servicing the vehicle. If thevehicle is equipped with a locking pin, ensure that it is securely installed. Do not lower bed until allpersons are clear of cargo bed area. Keep hands clear of all crush areas. Do not drop cargo bed; lower gently and keep entire body clear. Failure to heed this warning could result in severe personalinjury or death. 121.LockingPin2.BedLockingPinHoles Figure 9 Bed Locking Pin REAR SHOCK ABSORBERS The vehicle arrives from the factory with the rear coil-over shocks pre-adjusted for optimum vehicle performance. CAUTION • Do not adjust the rear shock absorbers. Damage to the shock absorbers could result. 2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 25 Loading and Unloading Cargo LOADING AND UNLOADING CARGO WARNING • Engage park brake before loading vehicle. • Do not allow riders in the cargo bed. • Reduce vehicle load and speed when driving up or down slopes or on uneven terrain. • Do not exceed rated vehicle capacity. Rated capacity is for level surfaces only. • Overloading can affect vehicle handling or cause component failure, resulting in loss of control ofvehicle and possible severe personal injury or death. • Do not load tailgate. The tailgate should be in the upright position and latched securely while thevehicle is in motion. • To help avoid shifting vehicle load and possibly overturning the vehicle, avoid sudden starts, suddenstops and abrupt turns. Make sure cargo is well secured. • Avoid top-heavy loads. The center of gravity of load should never exceed 15 inches (38 cm) abovethe bottom of the cargo bed. • The cargo’s center of gravity may affect handling, steering, and braking of the vehicle. When thevehicle is loaded, reduce speed and drive slowly in turns. • Unload cargo bed before raising vehicle with a lift, hoist, or jack. • Avoid stopping on a hill when loaded. If you must stop on a hill, avoid sudden starts, or rollingbackwards and stopping suddenly. Failure to heed this warning may cause vehicle to overturn, possibly resulting in severe personal injury. • Reduce speed and avoid sudden stops when backing up. Failure to do so may cause the vehicleto over...

Эта инструкция также подходит к моделям:
Оборудование к ТС - HUV 4214 (4.82 mb)
Оборудование к ТС - HUV 4414 (4.82 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории