Know the applications, the limitations and any hazards involved. [193017GS Rev 1 (03/21/03)] Part Number 531 30 01-12 Safety Rules TABLE OF CONTENTS Safety Rules. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4 Know Your Pressure Washer. . . . . . . . . . . . . . . . . . . . . . 5 Assembly. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-7 Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-10 Product Specifications. . . .
NEVER replace quick connect tip ! WARNING when gun is triggered. DETERGENTS The use of detergents can dramatically reduce cleaning time and assist in the removal of difficult stains. Many detergents are customized for pressure washer use on specific cleaning tasks. Pressure washer detergents are as thick as water. Using thicker detergents – like dish soap – will clog the chemical injection system and prevent the application of the detergent. Once applied to a cleaning surface, detergents take ti
• Keep operation area clear of all persons. • DO NOT overreach or stand on unstable support. Keep good footing and balance at all times. • Follow the maintenance instructions specified in the manual. Risk of injection or ! WARNING severe injury. Keep clear of nozzle. DO NOT discharge streams at persons. This product is to be used only by trained operators. ALWAYS remove lance from gun before cleaning debris from tip. • Keep clear of nozzle. NEVER direct high pressure spray at a person, animal, o
Surface Preparation ALWAYS engage the trigger safety latch when unit is not in use. The following cleaning procedure will help you organize your cleaning task and ensures that you will achieve the best results in the shortest amount of time. Remember to use the spraying / cleaning techniques mentioned in the following section. Before starting a pressure washer cleaning job, prepare the surface you intend to clean. Clear furniture from the area and make sure that all windows and doors are closed
Each 100 hours of operation or every 3 months • Clean or replace paper air cleaner cartridge. Tap gently to remove dirt. • Change engine oil. Every 500 hours of operation (5 months) • Change pump oil. Cannot check or change pump oil on the 5525PW. NOTE: This is a general maintenance schedule. Refer to the Engine operation manual for specific information on your engine. 18 — English TECHNICAL AND CONSUMER INFORMATION Pressure Washers Engine Oil Type SAE 10W-30 SAE 30W (Above 60 °F/15.7° C) Engine
Changing or refilling the oil in the pump requires removal of the pump from the engine and should not be required unless oil has leaked out due to worn or damaged oil seals in the pump. If oil has leaked out of the pump, bring the pressure washer to a certified service center for repair. For models 6027PW, 9032PW, and 1340PW: These units all have a sight glass to check the oil level and have a drain plug to remove the old oil when changing. To add oil remove vent cap from top of pump [See Figure
English CONTENTS Contents CONTENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 KEY TO SYMBOLS . . . . . . . . . . . . . . . . . . . . .2 Symbols in the Operator’s Manual . . . . . . . . .2 INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . .3 Dear Customer . . . . . . . . . . . . . . . . . . . . . . . . .3 WHAT IS WHAT? . . . . . . . . . . . . . . . . . . . . . . .4 What is what on the pressure washer . . .
Hold the gun and lance in a vertical position and squeeze the trigger to drain the water. Never store the pressure washer ! CAUTION with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure. NOTE: To winterize unit, please follow the same intructions for Storage. TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE WASHER • NEVER operate the unit without water. • Your pressure washer is not meant to pump hot water.