Оценок - 5, средний балл: 3.6 ( )

Производитель: Electrolux Размер: 729.38 kb Название файла: Язык инструкции:

2) DELTA FRONT HANDLE Secure the handle in front of the label placed on the shaft 11 cm from the rear grip when assembling nylon string head and 36 cm when assembling metallic blades. This position ensures optimum balance and safety. The handle must be perpendicular to the shaft as illustrated (Fig.2).The handle bar must be mounted using all the items supplied and in the exact configuration shown in figures 1 or 2. 3) DOUBLE HANDLE Adjust and secure double hand clamp by tightening the screws. I. Starting and stopping the engine WARNING: Before using the product every user should carefully read the sections SAFETY, SAFETY USAGE and SYMBOL MEANINGS. STARTING A COLD ENGINE 1) Position the on/off switch to the I (ON) position, away from the «STOP» position. 2) Rotate the choke lever in the direction illustrated by the arrows. This engages the fast idle system. 3) Squeeze the primer bulb (C) several times until you see fuel begin to return back through the tube (D) towards the fuel tank. Push the decompression valve (B) down if your models is fitted with one. Pull the starter handle until the engine starts. 4) Hold the machine safely and allow the engine to run for a few seconds. Grip the control handle firmly, pushing down on the safety trigger (S) and then squeezing the accelerator trigger (A). This action automatically releases the spring loaded choke lever (E) disengaging the fast idle system. WARNING: The fast idle system does cause the cutting attachment to rotate when engaged. ENGLISH - 5 STARTING A WARM ENGINE Position the on/off switch to the I (ON) position. Squeeze the primer bulb (C) several times until you see fuel begin to return back through tube (D) to the fuel tank. Push the decompression valve (B) down if your model is fitted with one. Pull the starter handle until the engine runs. 5) STOPPING THE ENGINE Push the on/off switch to the STOP position. WARNING: After the engine has been switched off, the rotating cutting attachment, blade or string head, will continue to rotate for a few seconds due to their inertia. Continue to hold the machine firmly off the ground until it stops completely. Keep your hands away whilst it is moving. N.B. In an emergency, the cutting attachment can be stopped quickly by touching it parallel to the ground after moving the switch to the «STOP» position. L. Carburettor adjustment To adjust the idle speed, however, proceed as fol lows: With engine running and warm, slowly turn screw ‘T’ clockwise until the engine runs smoothly with a consistent noise level but without making the cutting head rotate. If the cutting attachment does move or the engine runs too fast, slowly turn screw ‘T’ in an anti- clockwise direction until the correct speed is obtained. Precise numerical engine speed settings are mentioned in the technical detail chart in the front of the owner’s manual. M. Regular maintenance From time to time ensure all screws are tight. Replace damaged, worn, cracked or warped blades. Always make sure nyl...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: