• The fine adjustment stop cannot be use to reduce the plunge depth when the depth rod is already touching the depth stop turret. The router must be raised before such an adjustment can be made. • Also available is an alternative turret that has an adjustable step which uses an M4 screw for the adjustable step. The adjustable step makes it possible to make multiple-pass applications without having to make a fine depth adjustment even when the total cutting depth is not a multiple of 1/8". -14 BM

de ce manuel. L.emploide pieces non autorisees ou le non-respect des instructionsd.entretien peut creer un risque de choc electrique ou deblessures. Regle de securite particuliere supplementaire:pour defonceuses 2. Tenez l.outil par ses surfaces de prise isoleespendant toute operation ou l.outil de coupe pourraitvenir en contact avec un cablage dissimule ou avec sonpropre cordon. En cas de contact avec un conducteur soustension, les pieces metalliques a decouvert de l.outiltransmettraient un cho

Please call Compatible Systems Technical Support if your router shows a software panic. Appendix C -LED Patterns and Test Switch Settings MicroRouter 1220i Switch Settings 0 Normal Operation 1 Unused* 2 Unused* 3 Run Boot ROM Downloader 4 Unused* 5 Erase Flash ROM (OS and Configuration) 6 Erase Flash ROM (Configuration Only) 7 Unused* 8 Unused* 9 Allow letmein password for 5 minutes after powerup . Caution: Settings marked with an asterisk may erase your Flash ROM. Please do not use these settin

.........................................1 .................6292563-MFC.........Motor Fan Cover (not shown) ...................... .........................................1 .................6292563-CS............ Centrifugal Switch (not shown) .................... .........................................1 .................6292563-SC............Starting Capacitor (not shown) ....................400MFD, 250VAC.............1 .................6292563-RC............Running Capacitor (not shown) ...

Some examples of these chemicals are: • lead from lead-based paints, • crystalline silica from bricks and cement and other masonry products, and • arsenic and chromium from chemically-treated lumber. The risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as dust masks that are specially designed to filter out microscopic particles. Technical da

Always use router bits with the shortest cutting length necessary to produce the desired cut. This will minimize router bit run- out and chatter. FIG. 12 PILOT OR BEARING SLIDES ALONG EDGE OF CUTTER PART OF PILOT TIPPED BIT CUT WORKPIECE -12 BM 2610943371 07-06.qxp 7/24/06 9:03 AM Page 13 BM 2610943371 07-06.qxp 7/24/06 9:03 AM Page 13 DUST COLLECTION WHILE The dust extraction hood itself is sized to EDGE FORMING accept 35mm vacuum hoses. Also included is The RA1170 dust extraction hood (optiona

OR — To most precisely re-center the subbase, attach the sub-base using the optional Bosch centering cone, an optional Bosch templet guide, and the set of pan-head screws (included). (Pan-head screws have rounded tops.) Follow steps 1-8. FIG. 18 OTHER BASES 1. Position the sub-base so that its pan-head screw holes are over the matching set of threaded holes in the base. 2. Insert the pan-head screws, not the flathead screws, through the sub-base and tighten them until they are snug, but still al