Войти:
Скачали: 1   Размер: 2 mb   Производитель: Powermatic  
Категория: Кромочные фрезеры
@name

Its purpose, aside from machine operation, is to promote safety using accepted operating and maintenance procedures. To obtain maximum life and efficiency from your jointer and to aid in using it safely, please read this manual thoroughly and follow the instructions carefully. Warranty and Service WMH Tool Group warrants every product it sells. If one of our tools needs service or repair, one of our Authorized Repair Stations located throughout the United States can provide quick service or info

Скачали: 1   Размер: 259 kb   Производитель: Powermatic  
Категория: Кромочные фрезеры
@name

POMfBMMIlC PJ1696 The new 16-inch jointer offers big capacity and performance in a machine that is loaded with features. Large center-mounted fence assembly adjusts easily via rack and pinion system with ram lock. Preset stops on the fence body allow for fast angle set-up at 45 degrees in and out and a positive stop for perfect 90. ■ The Parallelogram design keeps the table in close proximity to the cutterhead for improved finish and allows for a fast depth of cut adjustment. This design also

Скачали: 3   Размер: 3 mb   Производитель: Powermatic  
Категория: Кромочные фрезеры
@name

Then rotate the key so that the arrow lines up with the LOCK arrow on the cover. This will prevent the safety key from coming loose from vibration when the machine is in use. Figure 30 21 Basic Jointer Operation NOTE: If you are inexperienced at jointing, use scrap pieces of lumber to check settings and get the feel of operations before attempting regular work. This section briefly discusses general rules as well as some of the basic cuts using a jointer, such as surfacing, edging, beveling, ske

Скачали: 2   Размер: 3 mb   Производитель: Powermatic  
Категория: Кромочные фрезеры
@name

1 55............. 6296062...................Bolt........................................................................................................ 1 56............. 6296063...................Collar .................................................................................................... 1 57.............TS-0680031.............Flat Washer........................................................5/16”...........................6 59............. 6296167...................Depth Scale.

Скачали: 1   Размер: 3 mb   Производитель: Powermatic  
Категория: Кромочные фрезеры
@name

Proceed as follows: 6. Rotate the cutterhead (using the pulley) until the tip of the knife is at the top of the cutterhead arc. Place the knife setting gauge (Figure 17) over the cutterhead so the tip of the knife contacts the center of the gauge, and all four "feet" of the gauge rest firmly upon the cutterhead, as the knife is pushed down into its slot. The gauge will set the knives at approximately .070" above the cutterhead. Knife height should not vary more than .002-.003" across the length

Скачали: 40   Размер: 2 mb   Производитель: Powermatic  
Категория: Кромочные фрезеры
@name

.........................................1 .................6292563-MFC.........Motor Fan Cover (not shown) ...................... .........................................1 .................6292563-CS............ Centrifugal Switch (not shown) .................... .........................................1 .................6292563-SC............Starting Capacitor (not shown) ....................400MFD, 250VAC.............1 .................6292563-RC............Running Capacitor (not shown) ...





Категории