Войти:
Оценок - 2, средний балл: 3.5 ( )

Инструкция по эксплуатации Braun, модель UVL 604XA

Производитель: Braun
Размер: 1.49 mb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Note: The lift platform will not raise if the roll stop is not in the UP position. This is a built-in safety feature. The LIFT DOWN function lowers the platform to ground level. The outboard roll stop automatically unfolds to ramp (horizontal) position when the platform contacts the ground to allow the wheelchair passenger on or off of the lift. The roll stop must be Fully-Unfolded (Ramp position) Outboard Roll Stop Bridge Plate (Inboard Roll Stop): UVL lift models may be equipped with an automatic or manually operated bridge plate (except model UVL603A). The bridge plate bridges the gap between the lift platform and the vehicle floor as well as serving as an inboard roll stop. Automatic Bridge Plate: Automatic bridge plates are spring- fully unfolded before the front and rear wheelchair wheels (or standee) have crossed the roll stop. Although the outboard roll stop is lift-powered and fully-automatic in operation, mechanical failures are possible. Discontinue lift operation immediately if the roll stop does not operate properly. Outboard Roll Stop Electric Actuator loaded to raise to vertical position when the platform extends from the stow position. The automatic bridge plate folds down onto the vehicle floor as the platform raises to floor level. The bridge plate automatically folds down to the platform surface during the lift stow function. Discontinue lift operation immediately if the automatic bridge plate does not operate properly. WARNING Discontinue lift use immediately if any lift component does not operate properly. Failure to do so may result in serious bodily injury and/or property damage. Fully-Folded (Up-vertical) Outboard Roll Stop Manual Bridge Plates: Manual bridge plates are attendant operated. The bridge plate rests on the platform surface when the lift is in the stowed position. When the platform is fully- extended, the bridge plate is manually raised to the vertical position. When the platform is raised to floor level, the bridge plate is manually lowered to the vehicle floor (bridging position). Automatic Bridge Plate (Inboard Roll Stop) Vertical Position Floor Level (Bridging Position) Vehicle Floor Platform Below Floor Level Vehicle Floor Platform at Floor Level Page 8 Pre-Lift Operation Notes Further details and instructions for operation of manual bridge plates are provided in the Manual Bridge Plate Operating Instructions (see page 12). Handrails: UVL lift models may be equipped with one of three types of handrails - Stationary Handrails, Manual Fold “P” Handrails or Manual Fold “U” Handrails with Safety Side Shields. Handrails are standard equipment on most lift models and optional equipment on others. Passengers should grip both handrails when on the lift platform if possible. Become familiar with the proper operation of the style of handrail your lift is equipped with (if so equipped). Stationary handrails remain in the upright (vertical position) at all times and require no operation procedures (see page 13 for details). Refer to the applicable handrail instructions for details and operation procedures for folding handrails on pages 13 and 14. Discontinue lift operation if the handrails do not operate properly. WARNING Face outward and lock wheelchair brakes before operating lift. 81814 Lift Passengers: Do not attempt to load or unload a passenger in a wheelchair or other apparatus that does not fit on the platform area. Do not exceed the 750 pound rated load capacity of the lift. Passenger Orientation (Boarding Direction): Inboard facing of wheelchair passengers is not prohibited, but outboard facing of passengers is recommended by The Braun Corporation. Passengers loading from ground level should back onto the platform. Passengers loading from floor level should proceed onto the platform facing outward (outward from the vehicle). The passenger must be positioned in the center of the platform to prevent side-to-side load off-balance. The lift attendant (operator) should not ride on the platform with the passenger. Wheelchair brakes must be locked whenever the passenger is on the platform. Turn powered (electric) wheelchairs off when on platform. If you are an attendant operating the lift, it is your responsibility to practice safe loading and unloading procedures. Observe your passenger at all times during lift operation. Vehicle (Floor Level) Loading/ Unloading: The platform must be fully raised (at floor level) and the bridge plate must be properly positioned (if equipped) when loading or unloading passengers in or out of the vehicle. Floor level positioning of the UVL platform is a fully automatic function, but it is the responsibility of the lift operator to ensure the platform and the bridge plate (if equipped) are properly positioned. If the lift does not position the platform properly, discontinue lift use immediately and contact an authorized Braun Corporation dealer in your area or call The Braun Corporation at 1-800-THE LIFT. One of our national service representat...

Эта инструкция также подходит к моделям:
Инвалидные коляски - UVL 603A (1.49 mb)
Инвалидные коляски - UVL 603B (1.49 mb)
Инвалидные коляски - UVL 603E (1.49 mb)
Инвалидные коляски - UVL 604XB (1.49 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории