Connect the antenna cable/wires from inside the wall to the rear connectors on the plate, then retighten the screws. Warning: Be sure the exposed portions of the cables/wires do not touch each other. 6. Use the two supplied short screws to secure the plate to the center holes of the brackets. 7. Use a flat-bladed screwdriver to loosen the screws at the back of the supplied three-prong cable plug. Connect the 300-ohm antenna wire from the audio and video outputs of the TV (or the left and righ

PFC-A (Female to Female Coupler) OMNI (Not Included) PFC Coupler 1 r 1 - fl V_!-■ <»-^P-A NPT pipes Available Sizes 12", 18", 24" (Not Included) (Not Included) Pouch # Part # Description Qty 1 COUPLER (PMD Series Compatible) 1 1 P-A SCREW 1/4 inch L 3/8 inch 4 1 P-B ALLEN KEY M4 1

..This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. ..Specifications are subject to change without prior notice. OMNIMOUNT PRODUCT WARRANTY ENGLISH ESPANOL ..This warranty applies to US Residents who purchase from an authorized OmniMount Dealer. OmniMount products are covered against defects in materials and workmanship for 5 years. OmniMount will repair or replace the defective component or product, at its sole discretion. Failure

ES Le produit reel peut differer de l'illustration. FR CAUTION EN USE WITH PRODUCTS LARGER THAN THE MAXIMUM WEIGHT AND SIZE MAY RESULT IN INSTABILITY CAUSING POSSIBLE INJURY. USER MUST REMOVE TELEVISION OR OBJECT OFF THE BRACKET BEFORE ADJUSTING. IF THE PRODUCT IS A TELEVISION MAXIMUM WEIGHT CAPACITY SUPERSEDES / OUTPLACES RECOMMENDED DIAGONAL MEASURED TELEVISION SIZE!! ES EL USO CON EL PRODUCTOS MAS GRANDE QUE EL PESO MAXIMO Y TAMANO PUEDE CAUSAR INESTABILIDAD Y POSIBLEMENTE HERIDAS. EL USUARIO

ES Le produit reel peut differer de l'illustration. FR CAUTION EN USE WITH PRODUCTS LARGER THAN THE MAXIMUM WEIGHT AND SIZE MAY RESULT IN INSTABILITY CAUSING POSSIBLE INJURY. USER MUST REMOVE TELEVISION OR OBJECT OFF THE BRACKET BEFORE ADJUSTING. IF THE PRODUCT IS A TELEVISION MAXIMUM WEIGHT CAPACITY SUPERSEDES / OUTPLACES RECOMMENDED DIAGONAL MEASURED TELEVISION SIZE!! ES EL USO CON EL PRODUCTOS MAS GRANDE QUE EL PESO MAXIMO Y TAMANO PUEDE CAUSAR INESTABILIDAD Y POSIBLEMENTE HERIDAS. EL USUARIO

CLAMP ASSEMBLY ORIENTATION A) Wall Mount A) Ceiling Mount C) Drywall Mounting Use W" drill bit Irvseit anchor into hole “Pop" ball into the clamp assembly. Set speaker to desired position. Tighten clamp assembly until snug. Note: Speaker weight must be lully supported during the tightening process. OMNI 10.0 SPEAKER MOUNT USER’S GUIDE REQUIREO TOOLS A. 5/32' hex wrench (supplied) Drill bits: B. Wood 5/32' C. Dr/Mail - W" 0. Masonry - VI6" carbide tipped E Crescent or 7/16* (11mm)

Every effort has been made to provide accurate and error- free assembly and installation. OmniMount Systems disclaims liability for any difficulties arising from the interpretation of information contained in these instructions. If OmniMount products are used for purposes other than their original intent, OmniMount, its distributors and retailers shall not be held responsible or liable for injuries or property damage, direct, indirect, or consequential, which may arise from the inability to use