vents through the wall or roof • 4" & 7" rear venting • Overall depth of 12" makes for endless installation possibilities with a minimum of space • No hearth extension required saving you space in smaller rooms • Ground level and above installations • Basement installations even below grade using a Periscope (#GD201) • Approved for installation in bathrooms, bedrooms and bed-sitting rooms • Suitable for mobile home installations • Hot air distribution kit optional • Approved with Simpson Dura-Ve

Read the instructions before use. This appliance must be installed inaccordance with such regulations asare in force. Do not use the heater in an explosive atmosphere. Keep the heater away from areas where gasoline or other flammable liquids or vapors are stored. Prior to use, check for damaged parts such as hoses, regulators, pilot or burner. Disconnect LPG bottle before moving the heater. Do not attempt to alter unit in any manner. EXAMPLE: using the heater without the top canopy reflector or

2. Extinguish any open flame. 3. if odor continues ,immediately call gas supplier. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WARNING: For Outdoor Use Only. CAUTION: Retain the instructions for future use. C E R T I F I E D ISGE ND CDE ER ITFI Manual,Instructions & Parts List 2 TOOLS AND PARTS NEEDED FOR ASSEMBLY TOOLS NEEDED: 7/16 Wrench 3/8 Open End Wrench Adjustable Opening Wrench, 8 Long Philips Head Screw

Tighten fittings using 2 wrenches. 6. When connecting regulator assembly to the tank valve, hand tighten black QCC1 nut clockwise to a positive stop. DO NOT use a wrench to tighten. Use of a wrench may damage the quick closing coupling nut and result in a hazardous condition. 7. Locate the hose out of pathways where people may trip over it or in areas where the hose may be subject to accidental damage. 8. Open tank valve fully (counter-clockwise). Turn the on/off valve at the unit slowly to the

• FOR OUTDOOR USE ONLY. • THIS APPLIANCE MUST NOT BE USED FOR COOKING. • THIS UNIT IS NOT FOR USE WITH SOLID FUEL • Improper installation, adjustment, alteration, service, or maintenance can cause injury or property damage. Read the installation, operating and maintenance instructions thoroughly before installing or servicing this equipment. • This appliance shall be used ONLY outdoors in a well- ventilated space and shall NOT be used inside a building, garage, or any other enclosed area. • Cyli

WARNING: -This grill is not to be used while the vessel is in motion. -When operating the grill on a vessel, only 8 oz cylinders that are DOT approved (2P/2Q) can be used in the United States. In Canada a 16 oz. cylinder may be used. These cylinders are available at your local marina or hardware store. -This grill is not to be mounted on a railing while the boat is in motion. It is highly recommended that the grill head is removed and stored away before casting off. Propane and butane can be mor

Please use this manual in conjunction with your main manual to properly assemble your built in grill. KIT CONTENTS BOTTOM PANEL 1PC SIDE PANELS 2PCS REAR PANEL 1PC #8 x y2” TEK SCREWS 15PCS #14 x y2” HEX HEAD SCREWS 6PCS Model Dimensions W D H BIZC450 35.875” 22.937” 11.125” BIZC600 44.125” 22.937” 11.125” The installation must be performed by a licensed gas fitter, and all connections must be leak tested before operating the grill. BUILT IN PROPANE GAS HOOK-UP: The piping up t

If the enclosure is to house a propane cylinder, the tank portion of the enclosure must be ventilated according to local codes, and must not have communication with the cavity used to enclose the gas grill. The tank can not be stored below the gas grill. BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as shown in the built-in instructions. Do not use hose to connect the unit. It must be connected with either rigid

M605RBCSS MIRAGE 605 CHARCOAL GRILL DANGER Burning charcoal gives off carbon monoxide. Do not burn charcoal inside homes, garages, tents, vehicles or any enclosed areas. WARNING Do not try to light this appliance without reading the “LIGHTING” instruction section of this manual. WARNING! Failure to follow these instructions exactly could result in a fire causing serious injury or death. NapoleonApplianceCorp., 214BayviewDr.,Barrie,Ontario,Canada L4N4Y8 Phone:(705)726-4278 Fax:(705)725-2564 email

If necessary, consult with a qualified inspector. The purpose of the turbo burner is to increase heat output or BTUs of the unit and will only operate when the main burner is functioning. To turn the turbo burner on, simply depress the burner control knob (located in the valve compartment at the left hand side below the piezo ignitor) and rotate the knob counter-clockwise to 'high'. The turbo burner flame can be observed on the reflective surface in the back right corner of the firebox. The burn