This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching. Page 1 of 1 6/19/08 © Travis Industries, Inc.
This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching. Page 1 of 1 6/19/08 © Travis Industries, Inc.
This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching. Page 1 of 1 6/19/08 © Travis Industries, Inc.
This allows the doors to be aligned left or right, top to bottom. NOTE: place a rag over the hinge posts before grasping the hinge posts with pliers to prevent scratching. Page 1 of 1 6/19/08 © Travis Industries, Inc.
Attach the mounting brackets included with this kit to the back of the glass frame, using the nuts removed earlier - make sure the brackets are installed with the notch on the lower side of the bracket (see Figure 1, item “b”). 2 Attach the glass frame to the fireplace by inserting the tabs on the mounting brackets into the slots on the fireplace (see Figure 2). Magnets hold the mounting brackets in place. Figure 2 Page 1 of 1 17601562 - 12/16/08 © Travis Industries, Inc.
*1 ''tU 22-1/2 Use the screws included with the face to secure the face to the brackets. WARNING: When attaching the Victorian Lace Face, do not over-tighten the screws. Over-tightening the screws may damage the face - simply tighten the screws until they contact the face. Page 1 of 1 11/5/07 © Travis Industries, Inc.
You must tip them under and around the corners of the burner. Carefully replace the front and rear grates (they rest on top of the floor firebacks). WARNING: When replacing the grate do not drag the grate across the firebacks (they damage easily). You may need to lift the burner slightly while installing the grate. NOTE: These tabs are bent out when using the accent light. Make sure to carefully bend them flush if the accent light was previously installed (then reposition them after fireback
Easy to start, easy to operate and easy to maintain. The Astoria Bay is designed to turn your inefficient open fireplace into a power house home heater (45,100 BTU/Hour). Adjust the feed rate to low and with the maximum fuel load (82 lbs.), you can expect up to 52 hours of continuous heating. Use the provided wall thermostat and stretch the burn time even longer. The computerized control panel allows you to operate the Astoria Bay manually or change to a fully automatic mode with the push of a b
From its exclusive auto igniter to its easy-to-clean components, it is the most reliable and easy to use pellet insert ever designed. EASY TO FUEL - The Newport Bay Pellet Insert is designed for convenience. The top lifts up and locks to allow easy access to the 35 lb. capacity hopper, which will provide you with up to 30 hours of uninterrupted heating. EASY TO OPERATE - The Newport Bay's unique circuit board allows you to run your pellet insert manually, by setting the feed rate and pushing the
Install the backing plate as shown in the illustration below. Page 1 of 4 TRAVIS IN DUSTRI HOUSE OF FIRE Printed April 16, 2008 Avalon Hideaway Bungalow Face (95700121) 2 Hang the left and right doors on the backing plate. Attach the handles and verify magnet position (if applicable). Page 2 of 4 ^,u,,iMoDru?";i# Printed April 16, 2008 Avalon Hideaway Bungalow Face (95700121) PUSH-ON FACE BRACKETS NOTE: The push-on brackets are only compatible with the 21 TRV (2008 or later). Overview