Войти:
Оценок - 5, средний балл: 4.4 ( )

Инструкция по эксплуатации Avalon Stoves, модель 21 TRV

Производитель: Avalon Stoves
Размер: 388.67 kb
Название файла: 80948b30-c5b0-41d4-8f9d-b36615ef1fde.pdf
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Install the backing plate as shown in the illustration below. Page 1 of 4 TRAVIS IN DUSTRI HOUSE OF FIRE Printed April 16, 2008 Avalon Hideaway Bungalow Face (95700121) 2 Hang the left and right doors on the backing plate. Attach the handles and verify magnet position (if applicable). Page 2 of 4 ^,u,,iMoDru?";i# Printed April 16, 2008 Avalon Hideaway Bungalow Face (95700121) PUSH-ON FACE BRACKETS NOTE: The push-on brackets are only compatible with the 21 TRV (2008 or later). Overview The optional push-on brackets allow the face to be installed up to 1” from the front of the fireplace. In addition, the new brackets allow the face to be installed straight-on to the fireplace. This permits the use of thick facing material directly above the face (no gap is required to slide the face into place). Tile Retrofit Installations If a 21 TRV is already installed into a standard drywall installation with the standard brackets, it is extremely difficult to install tile behind face (this requires the fireplace location to be moved forward). With the new push-on brackets, the face may be located up to 1” from the front of the fireplace, allowing tile or other non-combustible to be placed behind the face. Bracket Installation Remove the stock brackets and install the push-on brackets to the back of the face following the directions below. The upper brackets are installec facing to the left (this insures th i installed right side up).. 0 Note how the lower brackets angle inwards. Page 3 of 4 TRAVIS IN DUSTRI HOUSE OF FIRE Printed April 16, 2008 Avalon Hideaway Bungalow Face (95700121) Preparing the Fireplace for Thick Facing The 21 TRV has a sliding heat shield that must be properly positioned when using thick facing. See the directions below for adjusting the heat shield. Loosen these two nuts above the firebox (3/8” wrench). Slide the heat shield forward until it is flush with the facing and tighten the nuts to secure. Face Installation and Removal Face Attachment Face Removal Page 4 of 4 TRAVIS IN DUSTRI HOUSE OF FIRE Printed April 16, 2008...


Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории