Profiles definedA profile contains the initialization settings needed for communication between a device and device driver. The data in a profile is used by VWorks or BenchWorks software to identify each device on the network. A profile can also contain other basic settings that you are unlikely to change once set up. Because profiles identify device driver devices on the network, each device driver device must have its own profile. You can create, modify, and delete profiles as needed. Stored s

• STEP 2: Determine DC Battery Amps Required Divide the total wattage required (from step 1, above) by the battery voltage (12) to determine the DC amps required. • STEP 3: Estimate Battery Amp-Hours Required (for operation unsupported by the alternator) Multiply the DC amps required (from step 2, above) by the number of hours you estimate you will operate your equipment exclusively from battery power before you have to recharge your batteries. Compensate for inefficiency and wiring losses by mu

AC Introduction 2 Safety 2 Feature Identification 3 Operation 4 Application Guide 5 Mounting 5 Battery Connection 6 Troubleshooting/Service/Maintenance/Warranty 7 Warranty Registration 8 1111 W. 35th Street, Chicago, IL 60609 USA Copyright © 2010. PowerVerter® is a registered trademark of Tripp Lite. All rights reserved. Introduction Reliable AC Power Wherever You Need It! Congratulations! You’ve purchased the most advanced, feature-rich Inverter designed as a mobile energy source for your vehic

Key product features are: • 5V 0.5A power consumption • Supports resolutions to UXGA • Up to 165 MHz pixel rates Installation Figure 1: Location of Input/Output Connections 1. Connect the DVI source device to the splitter marked INPUT on the B116-002. (Figure 2) Figure 2: Connection of DVI Sources 2. Connect the DVI cables between the DVI displays and the B116-002 splitters marked OUTPUT MASTER and OUTPUT SLAVE. Make sure that the DVI source cables are connected to the INPUT port, and that and t

iv) If battery acid contacts skin or clothing, wash immediately with soap and water. If acid enters eye, immediately flood eye with running cold water for at least 10 minutes and get medical attention immediately. v) NEVER smoke or allow a spark or flame in vicinity of battery or engine. vi) Be extra cautious to reduce risk of dropping a metal tool onto battery. It might spark or short-circuit battery or other electrical part that may cause explosion. vii) Remove personal metal items such as rin

RVs and boats often experience severe shocks, while driving over potholes and rough road surfaces or while navigating in choppy seas. RVs and boats also experience constant vibration, from surface friction, drive engines and on-board generators. The RV1012UL and RV2012UL are engineered specifically to meet the challenges of demanding RV and marine environments—and are UL-tested to perform reliably under the most extreme shock and vibration conditions. The new RV1012UL and RV2012UL include all th

35th Street, Chicago, IL 60609 USA Package Contents: • B120-000-SL DVI Single Link Active Extender • External Power Supply (Input: 100-240V, 50/60Hz, 0.5A Output: 5V, 2A) • Screwdriver for Equalization Adjustment • Owner’s Manual Product Features: • Supports a maximum video resolution of 1920 x 1080 @ 60Hz • Extend a DVI-D video signal up to 150 ft. from the source • Built-in Equalization control to adjust the video image • HDCP compliant Installation Note: Test to make sure that the entire inst

• Do not attempt to service this unit. Instead, disconnect it and visit • Use of this equipment in life support applications where failure of this equipment can reasonably be expected to cause the failure of the life support equipment or to significantly affect its safety or effectiveness is not recommended. Do not use this equipment in the presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide. Package Contents • Local Unit • Remote Unit • VGA with Audio Splitter Cable • (

35th Street, Chicago, IL 60609 USA Note: Follow these instructions to ensure proper operation and prevent damage to this device and its connected equipment. Copyright © 2009 Tripp Lite. All rights reserved. All trademarks are the property of their respective owners. 2 Safety Information • To reduce the risk of electric shock, do not expose the product to moisture. • Operate this product using only the included external power supply. Use of other power supplies could impair performance, damage th

• Features built-in Equalization and Gain controls to adjust the video image • Supports video resolutions up to 1920x1440 • No drivers required Product Features Optional Accessories • P502-Series Monitor Cables with RGB Coax, HD15 Male/Male • N020-01K-GY Cat5e Bulk Stranded Cable, 1000 ft. • N022-01K-GY Cat5e Bulk Solid Cable, 1000 ft. • N222-01K-GY Cat6 Bulk Solid Cable, 1000 ft. Specifications Signal Type VGA, SVGA, XGA, UXGA and WUXGA Video Amplifier Bandwidth 350 Mbps Input DDC Signal 0.7 Vo