Operator’s Manual ES • Safety • Assembly • Operation • Maintenance • Parts • Espanol Visit our Sears website: Model No. 247.770550 CAUTION: Before using this product, read this manual and follow all Safety Rules and Operating Instructions. FORM NO. 769-00407C.fm (5/04) TABLE OF CONTENTS TABLE OF CONTENTS Content Page Content Page Warranty 2 Service and Adjustments 15 Safety 3 Storage 17 Assembly 6 Troubleshooting 18 Operation 9 Parts List 19 Maintenance 13 Espanol 23 WARRANTY Limited Warranty on

Operator’s Manual 28” SNOW THROWER Model No. 247.887900 • SAFETY • ASSEMBLY • OPERATION • MAINTENANCE • PARTS LIST • ESPANOL ® 7/6/2007 FORM NO. 769-02587A TABLE OF CONTENTS Warranty.Statement...................................Page.2 Repair.Protection.Agreement....................Page.3 Safe.Operation.Practices..........................Pages.4-5 Safety.Labels.............................................Page.7. Assembly...................................................Pages.8-11 Operation.......

foot GF ressure To raise the feed dogs, push (_) For dropping the feed dogs, the lever in the direction of push the lever in the direction dial: 0 Drop feed lever the arrow as illustrated. of the arrow as illustrated. Then turn the handwheel. * Feed dogs must always be up for normal sewing. 1 Drop the feed dogs. 2. Stretch the fabric with the hole in the center between embroidery hoops, as shown. 3. Lower the presser bar and sew a_ a siow speed. 4. Move the fabric bzick and forth slowly until yo

Pour les coutures definition. Pard acabado de eosturas. Use in smocking or as a decorative stitch, Les smocks conviennent bien pour falre des ornements sur des l_sstts ldgers. Usado en av_speros y otras puntadasdecoratwas. Finish hems. sleeve and neck openings. Use on nylon tricot and other fingerie to overcast and seam. Do shell tucking on blouses and lingerie. Fin#ion des ourlets, manches el eneohlres. Surfilage et coutures sur jersey de nylon et autres v_tements de lingerie. Confection de pli

Keep IMPORTANT SAFETY ventilation openings of the sewing machine and foot controller free from accumulation of lint, dust, and loose cloth. INSTRUCTIONS 5. Never drop or insert any object into any opening. 6. Do not use outdoors. Read all instruct=on before using this sewing machine, Your sewing machine is designed and constructed only for HOUSEHOLD use. 7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered. 8. To disconnect, turn all controls to t

• Stop engine and wait several minutes before checking oil level. Remove oil fill cap and dipstick. • Wipe dipstick clean, insert it into oil fill hole and tighten securely. • Remove dipstick and check. If oil is not up to the FULL mark on dipstick, add oil. Changing Oil Change engine oil after first two hours of operation and every 25 hours thereafter. In order to change the oil, you will have to first drain the spent engine oil from the engine and then refill with fresh oil. • Drain oil while

Put the darning plate on the needle 1. Set the same as satin stitch. plate (see page 29), 2. Back the fabric with paper or 2, Remove foot holder (see page 10), Stretch Stitch 3. interfacing. Draw the letters on the fabric No pre_er foot Stretch Stitch 3. Adiust the stitch (see page 21 ), width as desired with tailor's chalk. 4. Draw the design on to the fabric F' Satin stitch foot 4. Satin stitch, adjusting the stitch Darn m9 plate with tailor's chalk. width as necessary to form each 5. Stretch

Use SAE 5W30 engine oil only. FILL OIL This snow thrower was shipped with a container of 5W30 oil. This oil must be added to the engine before starting. For extreme cold operating conditions of 0° F or below, use a partial synthetic 0W30 motor oil for easier starting. NOTE: In areas where temperature is consistently at 2CP F or lower, you may use 0W30 motor oil for easier starting. • Remove the oil fill cap/dipstick. • Pour the oil and fill the crankcase to line (Full) on dipstick (19 ounce

C459.627020 CAUTION: Before using this product, read this manual and follow all safety rules and operating instructions. • SAFETY • ASSEMBLY • OPERATION • MAINTENANCE • PARTS LIST • FRANCAIS, p. F1 • ESPANOL, p. E1 Sears Canada Inc., 222 Jarvis Street, Toronto ON M5B 2B8 Visit our website: 769-03581 RULES FOR SAFE OPERATION The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, and their explanations, deserve your careful attention and understanding.

Here's How There are many ways to sewa ztgzag stitch. Consult the specific variations for detailed directions. Satin Stitch page 36, Applique Work page 37, Bar Tacking page 37, Monogramming page 38, Embroidery page 38, Button Sewing page 39, Overcasting page 40. .:. Satin Stitch Set the Machine Zigzeg width Stitch width Slllch length : e € 2 _controf2tO_l 2 3 4-s Top thread teRston (_3 contro_ 3 to 8 Stitch tenglh t control 0.5 to 1 Close to 0 Stretch Stitch F: Satin stitch foot Pressuredial: 1