Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
default for the 9500 series. However, if the cable services uses HRC or the TV appears to search for the “created channel”, channel injector for HRC. For HRC enter 98. Reset to IRC by entering 99. Entries 98 and 99 are for setting HRC or IRC only. They will not change the channel number. With programming complete, test each TV in the system to see that it is receiving the new channel. How to Determine which source on and one unused channel avoid interference. channels and appear © 1999 Upper right corner onchannel injector green LED programming button To program: For example channel 60 1: Press the button 6 times. 2: Wait for the LED to relight. 3: Press the button 10 more times (pressing 10 times enters “0”). The injector will now combine the camera feed on channel 60 with existing channels from the incoming CATV or antenna. To program a three digit channel: For example channel 120 1: Press the button 1 time. 2: Wait for the LED to relight. 3: Press the button 2 more times. 4: Wait for the LED to relight. 5: Press the button 10 more times. Finding Unused Channels CATV: Determine the highest channel number delivering a picture, excluding 95-99. Tune the TV up one channel at a time from the last channel with a picture until finding one channel with no trace of a picture or interference, just snow. Antenna: Tune the TV one channel at a time from channel 14-64. Locate one channel that has no trace of a picture or interference, just snow. Channel At the channel connect Cat color coding on blue/white pin 1 © 1999 When using only quad wire use positions 1, 2, 5 and 6 and follow color coding. green pin 1 run the Cat 5 wire through the grommet at the bottom of the injector Applying Power and Programming Step Three The 9500 series has three different methods for applying to the system. Use only one method for applying power. Method One: Apply power directly to the channel injector with the power supply. power supply Power plug © 1999 Lower right of channel injector The green LED in the upper right corner of the injector will be lit showing power is active. (See power length requirements page 9) Method Use the power injector to apply power Power Length 5 or quad wire Method One the power injector. Connect the plug the power power supply power injector pin 1 blue/white cut Cat 5 wire power plug Up to 100’ for the 9521 Color Power Length Requirements Method Two The green LED in the upper right corner of the channel injector be lit showing power is active. the 9511 B&W. Up to 100’ for the 9521 Color Method Three: Apply power directly at the camera. Power Length Requirements -+ -+ Method Three cut the power supply cord and strip the wires end removed wire with the white stripe connects to the (+) terminal power supply 7 6 Up to 300’ of Cat 5 or quad wire maximum for the 9511 B&W. power plug power plug Up to 100’ of Cat 5 or quad wire maximum Up to 300’ of Cat 5 or quad wire maximum for power supply with Up to 100’ of Cat 5 or quad wire maximum ...
Эта инструкция также подходит к моделям:Домашние кинотеатры - CAT CAM 9511BID B&W (144.25 kb)
Домашние кинотеатры - CAT CAM 9511PAL B&W (144.25 kb)
Домашние кинотеатры - CAT CAM 9521HHR COLOR (144.25 kb)
Домашние кинотеатры - CAT CAM 9511HHR B&W (144.25 kb)