. To program the Variable Auto Off: 1. Turn the function knob to “Auto Off.” Press and hold the “Hour” button for 2 seconds. The clock display will start blinking. 2. Program the coffeemaker to shut off from zero to four hours after brew cycle is finished by using the “Hour” and “Minute” buttons (see “To set the time”). 1 - 4 Cup Setting: The 1- 4 cup setting button is used when you make small amounts of coffee. The 1-4 setting basically ‘double heats’ the water, making your smaller amount pipin

Stored too cold, the aroma and flavor of the wine will be diminished. Stored too warm, the flavor of the wine can become too harsh, flat in flavor, or taste too strongly alcoholic. Because it is carefully limited to a temperature range that will preserve and enhance wines, any setting of the Cuisinart™ Private Reserve™ Wine Cellar is appropriate for storing most wines. The only exceptions are: – Champagne is best stored at presets 1, or 3 – Red wine is best stored at presets 4, 5, 6, 7, or 8 STO

1. Make sure unit is plugged into outlet. 2. Make sure air has been purged from internal tanks, as stated on page 5. 3. If there is water in the tanks, it will take about 80 minutes for the water to chill the first time. It takes only about 30 minutes for subsequent fi ll-ups. COLD water LED light turns off even though cold water is not dispensed. Large amount of room temperature water was dispensed. Allow up to 30 minutes for water to chill and LED light will turn on. Energy Saver mode LED does

1. Turn the unit off and unplug it from outlet. 2. Remove and empty upper tank. 3. Remove the filter and place it in a bowl. NOTE: To install a new filter or recondition the existing one, follow WATER FILTER SETUP instructions on page 4. 4. Remove and empty lower tank. 5. In the lower tank mix . gallon of distilled (white) vinegar and . gallon of tap water. 6. Place lower tank back on base. 7. Draw the following amount of water from each spigot: 21.8 cups of hot, 1. cups of room temp, 3. cups of

NOTE: You may reset the timer at any time by pressing and holding the Start button for 3 seconds. OPERATING INSTRUCTIONS Once setup is completed, tanks are filled and water is flowing steadily, your unit is ready to use! 1. Close the lid and plug unit into outlet. 2. Press the On/Off power switch on the control panel to turn on. The BLUE light around the power switch indicates the unit is on and cooling and heating functions are activated. 3. After about 15 minutes, the RED hot water indicator w

PARTS 1. Stainless steel veneered door with handle . Tinted double-pane window 3. LED display 4. Cabinet 5. Control panel 6. 3 removable chrome wine racks 7. Interior light control 8. Circulating fan USING YOUR WINE CELLAR Remove all packaging and any promotional labels or stickers from your wine cellar. Be sure that all parts (listed above) of your new wine cellar have been included before discarding any packaging materials. You may want to keep the box and packing materials for use at a later

To activate this feature, move the display light switch to the ON position. This switch is located INSIDE the door, above the window (see Parts, page 2). The interior light will remain ON permanently while in this position. When in the OFF position, the interior light will illuminate only when the door is opened. CLEANING AND CARE Always unplug the wine cooler before cleaning. Do not use benzene, scrubbing brushes or chemical cleaners, as these will damage the unit. Use only a mild, nonabrasive

Referring to Figure C, the adapter must be grounded by attaching its grounding lug under the screw of the outlet cover plate. NOTE: Do not remove the grounding prong. CAUTION: Before using an adapter, it must be determined that the outlet cover plate screw is properly grounded. If in doubt, consult a licensed electrician. Never use an adapter unless you are sure it is properly grounded. Note: Use of an adapter is not permitted in Canada. CONTENTS USING YOUR WINE CELLAR Important Safeguards . . .

Use this appliance only as described in this manual. Other uses not recommended may cause fire, electric shock or personal injury. 2. This product is intended for household use only. 3. To protect against electric shock, do not immerse unit, plug or cord in water or spray with liquids. 4. Close supervision is necessary when any appliance is used by or near children. 5. Unplug from the outlet when not in use or when moving from one location to another, and before cleaning. 6. To disconnect the ap

You may wish to store the packaging for future use. 2. Position the unit on a stable flat surface, close to a main power outlet, not in direct sunlight and out of the reach of children. 3. Make sure that there is sufficient space around the water dispenser to allow the heat extracted during the chilling process to dissipate. Allow at least 3" of space around the sides and rear of the unit for air circulation. 4. Lift the lid and, using a suitable jug, pour 1 gallon of tap water into the tank. Wh