Оценок - 4, средний балл: 4.3 ( )

Производитель: Avanti Размер: 528.89 kb Название файла: Язык инструкции:

So you are asked to be careful - because of the above - when placing foods wrapped in paper into the appliance. In case of increased demand e. g. during heatwawes, the refrigerator temporarily happens to operate constantly - during this the automatic defrosting does not work. Remaining small ice and frost stains on back plate of the refrigerator after defrosting period is not abnormal. Defrosting of the freezer is automatic in this model. Regular cleaning Clean the equipment regularly. Don't use detergents, abrasive or strongly odorous cleaners, waxy polishing agents or disinfectants or alkoholic products for cleaning the equipment. Before cleaning pull out the wall plug of the equipment from the outlet. Internal cleaning Clean the internal parts of the equipment and the accessories with warm water and sodium bicarbonate (5 ml to 0.5 litre of water). Rinse and dry everything thoroughly. Clean the door seal profile with clean water. External cleaning Clean the external parts of the equipment with warm water and sodium bicarbonate (5 ml to 0.5 litre of water). It is recommended to remove the dust and dirt deposited on the back side of the equipment and on the condenser once or twice a year, and to clean the evaporation tray on top of the compressor. After cleaning, reconnect the equipment to the mains supply. If something does not work During operation of the appliance some smaller but annoying trouble can often occur, which does not require calling a technician out. In the following chart information is given about them to avoid unnecessary charges on service. We draw your attention that operation of appliance goes with certain sounds (compressor- and circulating sound). This is not trouble, this goes together with the operation of the appliance. We draw it to your attention again that the appliance operates discontinuously, so the stopping of compressor does not mean being no-current. That is why you must not touch the electrical parts of the appliance before breaking the circuit. Problem Possible cause Solution It is too warm in the Thermostatic control can be set Set the thermostat knob to higher refrigerator. wrongly. position. If products are not cold enough or Place the products according to the placed wrongly. chapter „Storing in the refrigerator”. The door does not close tightly or it is Check if the door closes well and the not shut properly. gasket is unhurt and clean. It is too warm in the Thermostatic control can be set Set the thermostat knob to higher freezer. wrongly. position. The door does not close tightly or it is Check if the door closes well and the not shut properly. gasket is unhurt and clean. Products in big quantity to be frozen Wait some hours and then check the were put in. temperature again. Products to be frozen are placed too Place the products in a way so that closely to each other. cold air could circulate among them. Water flows at the It is normal. During automatic defrost- back plate in the ing frost melts on the...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: