Оценок - 1, средний балл: 5 ( )

Производитель: Wolf Appliance Company Размер: 193.97 kb Название файла: Язык инструкции:

A 10" (254) round duct is recommended for pro ventilation hood liners. Use only rigid metal ductwork, do not use flex ducting. Decide where the ductwork will run between the hood liner and the outside. Pro hood liners have a vertical discharge. A straight, short duct run will allow the ventilation hood to perform most efficiently. Limit the number of elbows and transitions. The duct run should be no longer than 50' (15 m). There is a possibility of noise issues, if a remote blower is used with a short duct run. Unless you are using a remote blower, a roof or wall cap must be installed. Connect 10" (254) round metal ductwork to the cap and work back towards the hood. Use duct sealing tape to seal joints between ductwork sections. Pro hood liners have a backdraft damper included in the transition assembly. Local codes may require the use of an additional backdraft damper. Contact your local HVAC professional for specific requirements. In cold weather installations, a backdraft damper is necessary to minimize the backflow of cold air into the room. Local building codes may require the use of make-up air. Consult your local HVAC professional for specific require- ments in your area. PRO HOOD LINERS DUCTWORK INSTALLATION THROUGH ROOF 30" (762) TO 36" (914) BOTTOM OF HOOD TO COUNTERTOP 12" (305) LINER HEIGHT 221/2" (572) LINER DEPTH 12" (305) 4" (102) DECORATIVE HOOD Pro Hood Liner Installation wolfappliance.com/specs Wall Framing 1) Layout dimensions of the back of the hood liner on the wall. Dimensions will vary with the width of the hood liner. Refer to the illustration and chart on page 7. 2) Using minimum 2" (51) x 4" (102) lumber, construct the wall framing flush with the wall studs and centered in the location that the hood liner will be mounted. Proper structural support is required to accommodate the weight of the hood liner. 3) Refer to the illustrations below for the location of mounting holes for pro hood liners and a cross-section view of a typical installation. Framing must be fastened together and to ceiling joists to provide enough structural strength to support the weight of the hood and internal blower, if applicable. DECORATIVE HOOD 23/4" 2" #10 x 2" (51) (51) (70) SCREW 4" 8" (203) (102) Location of mounting holes. Installation cross-section. Hood Liner Preparation IMPORTANT NOTE: For pro ventilation hood liners using an internal blower, refer to installation instructions provided with the blower assembly. 1) Remove the filters of the hood liner by pushing each filter up at the angle it is placed in, then rotate the bottom of the filter down. Refer to the illustration below. Remove the center filter first. Gloves should be worn when handling filters. 2) The hood liner is shipped with the transition attached upside down in the top of the hood liner. It must be removed and reinstalled in the proper position. Remove the blower mounting plate from the hood liner by removing four nuts from inside the liner. Detach the transition by remov...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: