Оценок - 3, средний балл: 3.7
(
)
)
|
Фрагмент инструкции
Direct drive centrifugal forward curve blowers, Multi-speed providing 400 to 650 cfm. one in each air stream. Two efficient three speed PSC double shafted motors 120 V, 2.75 Amps each (5.5 Amps total on high speed), 1 ph. 1/10 HP, 1625 RPM. Watts - total on high speed - 648. Washable filters, one in each air stream protect the core. Easy to access and clean. Installation accessories and controls make installation simple. ALDES Model HRV 700SFD or 700SDD is a compact heat recovery ventilator designed to exhaust stale indoor air and supply fresh air from outdoors. It is intended for small commercial and institutional applications, such as office buildings, classrooms, dormitories, restaurants, health clubs, etc. It is a technically advanced controlled mechanical ventilation system to meet the requirements of modern, tightly built and highly insulated buildings. It provides a consistent supply of fresh air while lowering heating costs during the winter by transferring heat from the exhaust air to the fresh air stream. During the summer it also reduces the load on the air conditioner by lowering the temperature of the fresh outdoor air. The system provides an economical solution for excessive indoor humidity, odors, stuffiness, and other indoor air pollutants. As the two air streams pass through the HRV, they are separated by thin plates of aluminum in the core. The air streams do not mix, so there is no recontamination of the fresh air by stale air. Heat passes through the thermally conductive aluminum from the warmer air stream to the colder air stream, recovering most of the energy otherwise lost to the outdoors. PART NO. 700SFD / 28 105 700SDD / 28 106 temperatures rise above 23 °F. The Model 700SDD blocks outside air during defrost and draws indoor air through the supply (with the same temperature and defrost time schedule as the fan defrost system). The Model 700 is available with two defrost options. The Model 700SFD begins the defrost cycle at temperatures below 23 °F (-5 °C) by shutting off the supply fan for 4-1/2 minutes, then resumes normal operation for 17 minutes, repeating the cycle until Optional Damper Defrost on Model 700 SDD PERFORMANCE PERFORMANCE OPTIONS AND ACCESSORIES 28 998: 60 MIN. REMOTE TIMER (2 Wire) 28 882 DEHUMIDISTAT - Activates high speed when indoor humidity rises above set point on control (2 Wire) Note: Manufacturer WARRANTY reserves the right to change Units carry a 15 year warranty onthe heat recovery core and a 2 specifications without notice. year replacement parts warranty. All units conform to CSA and UL Standards SPECIFICATIONS General: Unit shall be completely wired and includes blowers, filters, heat exchange cores and control panel. Cabinet: 29 5/8” x 28 3/4” x by 24 5/8” H. Constructed of 20 gauge satin white powder coated galvanized steel (G60) for superior corrosion resistance. Insulated with foil faced fiberglass duct liner to prevent condensation. Heat Exchange Core: Two modules, aluminum plate heat exchange core assembly held in stainless steel frame. Air filter: Four washable filters. Motors: Two efficient three speed PSC double shafted motors 120 V, 2.75 Amps each (5.5 Amps total on high speed), 1 ph. 1/10 HP, 1625 RPM. Watts - total on high speed - 648. Blowers: Centrifugal type rated at 700 CFM (329 L/s) free airdelivery. Each air stream has one double shafted motor drivinga centrifugal blower. Rubber isolated mounts. Controls: Illuminated power switch, 3 speed blower control, low voltage (24 VAC) terminals for connection of remote controls and defrost light indicating automatic operation. Defrost: Model 700SDD: Supply bypass routes indoor air to defrost core. Model 700SFD: Supply fan shuts off while exhaust continues to defrost core. (Defrost light indicates defrost mode- Preset 27° F (-3°C)). Duct Connections: Four 14" X 8" (356mm X 200mm). Model700SDD has fifth 14" x 8" duct connection on top surface. Drain Connections: Two 1/2" O.D. Mounting: Unit to be set in support brackets hung by threaded rod type apparatus. (Brackets and rod not provided). Weight: 142 lbs (64.4 Kg) Shipping Weight: 167 lbs (75.8 Kg) Manufacturer: American ALDES Ventilation Corp. 4537 Northgate Court, Sarasota, FL 34234 DIMENSIONS 700SDD / 700SFD BY MATHEWS GRAPHIC PROJECT DATE SUBMITTED BY CONTRACTOR 4537 NORTHGATE COURT SARASOTA, FL 34234-2124, USATel: 941 • 351- 3441 Fax: 941 • 351- 3442 e-mail: info@aldes-us.com 496HRV4-03 HIGH SPEEDMED. SPEEDLOW SPEED HIGH SPEEDMED. SPEEDLOW SPEED PRODUCT HRV 700SDD/700SFD PLUS SPECIFICATIIONS AND ENGINEERING HEAT RECOVERY VENTILATOR INFORMATION SPECIFICATIONS CORES -Modular (2 section) patented aluminum heat recovery cores arranged for efficient cross-flow ventilation. MOTORS - Two PSC, 3 speed single shafted, 120 VAC, 4.5 Amps each (9 total on high speed). HP - 1/4, 1450 RPM. Watts - total on high speed - 1032. FILTERS - Washable air filters in exhaust and supply air streams. BLOWERS -Centrifugal type rated at 329 L/s (700 C...
Эта инструкция также подходит к моделям:Вентиляторы - HRV 700SFD (3.6 mb)