Войти:
Оценок - 3, средний балл: 4.3 ( )

Инструкция по эксплуатации Hotpoint, модель 790.99014

Производитель: Hotpoint
Размер: 2.82 mb
Название файла:
Язык инструкции:
Перейти к скачиванию



Фрагмент инструкции


Once the surface controls have been set to the OFF positions and the clock has been set with the correct time of day, the surface controls should return to normal operation. If the surface controls do not funcfion and the "Er" message remains in any display after following these procedures, contact Sears Service for assistance. ESEC Lockout Feature ( --) The self-clean feature will not operate whenever a radiant surface element is ON. The ESEC feature will not operate during a self-clean cycle or when the Oven Lockout feature is active. Whenever the ESEC Lockout feature is active, "--" may appear in any display window (See Fig. 3). If any of the surface elements are still hot during active Lockout, "HE" wilt appear in the window instead of the "--" message. Operating Single Radiant Surface Elements The cooktop has single radiant surface elements at 2 locations; the right rear (Fig. 5) and left rear (Fig. 6) element positions. The BRIDGE element position can also be used as a single element (See Bridge Element Operating Instructions on pages 10-11). To Operate the Single Surface Elements: 1. Place correctly sized cookware on the radiant surface element. 2. Push in and turn the surface control knob in either direction to the desired setting using the ESEC digital display window for the desired setting (Fig. 4). Turn the knob to adjust the setting if desired. Start most cooking operations on a higher setting and then turn to a lower setting to finish iiiiiiiiiiiiii iliiii! ! !i!iii! cooking. Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. 3. When cooking has completed, turn the surface control knob to OFF before removing the cookware. Note: The HE message will appear after turning the control knob to OFF if the cooktop is still hot and will remain on until the heating surface area has cooled sufficiently. Figure 4 Note: See page 8, Figure 5for recommended control settings. ..... Figure 1 ..... Figure 3 Figure 5 Right Rear Element Figure 6 Left Rear Element 9 Setting Surface Controls FEATURE OVERVIEW Operating the Dual Radiant Element Surface Control Operating the Bridge Radiant Element Surface Control Figure 1 Figure4 Figure 2 Figure 5 Figure 3 Figure 6 iiiiiiiii iT--'i kiii Figure 7 Figure 9 Figure 8 Figure 10 Bridge element without Bridge element with Bridge Bridge portion. portion. Operating the Dual Surface Radiant Element The cooktop is equipped with a dual radiant surface element located at the right front (See Fig. 4) position. Symbols on the control panel are used to indicate which coil of the dual radiant element will heat. The • symbol indicates that only the inner coil will heat (Figs. 1 and 3). The _) symbol indicates that both inner and outer coils will heat (Figs. 4 and 6). You may switch from either coil setting at any time during cooking. To Operate t...

Эта инструкция также подходит к моделям:
Варочные панели - 790.99014 (2.82 mb)
Варочные панели - 790.99019 (2.82 mb)
Варочные панели - 790.99014 (2.82 mb)
Варочные панели - 790.99013 (2.82 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории