Оценок - 1, средний балл: 5
(
)
)
|
Фрагмент инструкции
• Ensure the countertop is square and level and ensure no structural members interfere with space requirements. • Prepare the cut-out according to the instructions (see cut-out dimensions). • Make sure the wall coverings, countertop and cabinets around the cooktop can withstand heat (up to 200 °F). 006 Figure 6. Tools you will need Step 1 Remove packaging materials and literature package from the cooktop before beginning installation. Remove Installation Instructions from literature pack and read them carefully before you begin. FILM TOP-CARDBOARD SIMMER PLATE WOK RING PRESSURE REGULATOR TOP PACKAGING COOKTOP SEP. CARDBOARD GRID BOTTOM PACKAGING 007 Figure 7. Parts Cooktop & Installation Manual Model COGB ENGLISH 9 Step 2 Before installing apply the foam tape. A tape is provided to seal the cooktop edges to the countertop. Apply tape near inner underside cooktop edge. Use tape around the entire cooktop perimeter. Cut off excess where tape butt ends. 008 Figure 8. Step 3 Insert the cooktop centered into the cutout opening. Make sure the front edge of the counter top is parallel to the cooktop. Make final check that all required clearances are met. 009 Figure 9. Step 4 Four clamp brackets are provided with your unit. After cooktop has been installed into the countertop, install the brackets on the burner box as shown in figure 10. Install the clamp brackets on the front and back of the burner box bottom (if the cabinet construction does not provide clearance for installing brackets at the burner box front back install the clamp brackets on the lateral position of burner box). step A place the clamping screws into brackets step B attach brackets by using the attachment screws on the selected location of burner box, tighten screws just enough to hold brackets in place step C positioning brackets so that they are with the clamp screw in contact with the counter top bottom step D tighten attachment screws securely. step E check that the front edge of the cooktop is parallel to the front edge of the countertop tighten the screw clamping against the countertop. DO NOT OVER TIGHTEN 010 Figure 10. Cooktop & Installation Manual Model COGB ENGLISH Gas Requirement A QUALIFIED SERVICE MAN OR GAS APPLIANCE INSTALLER MUST MAKE THE GAS SUPPLY CONNECTION. Leak testing of the appliance shall be conducted by the installer according to the instructions given. WARNING If the line pressure supplying the appliance pressure regulator exceeds 14 inches W.C. (any gas), an external regulator must be installed in the gas line ahead of the appliance regulator to reduce the pressure to no more than 14 inches W.C. Failure to do this can result in malfunction and damage to the appliance. Important Notes for Gas Connection The appliance and its individual gas shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psi (3.5 kPa). The appliance must be isolated from the gas supply piping syst...
Эта инструкция также подходит к моделям:Варочные панели - COGB 33060/L/BL (2.84 mb)
Варочные панели - COGB 33060/L/BL (2.84 mb)
Варочные панели - COGB33062/SS (2.84 mb)
Варочные панели - COGB 33061/L/WH (2.84 mb)