Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
SUNBEAM ® and SPRAY MIST ® are registered trademarks of Sunbeam Products, Inc. Distributed by Sunbeam Products, Inc., Boca Raton, Florida 33431. ©2002 Sunbeam Products, Inc. Tous droits reserves. SUNBEAM ® et SPRAY MIST ® sont marques deposees de Sunbeam Products, Inc. Distribue par Sunbeam Products, Inc., Boca Raton, Florida 33431. ©2002 Sunbeam Products, Inc. Todos los derechos reservados. SUNBEAM ® y SPRAY MIST ® son marcas registradas de Sunbeam Products, Inc. Distribuido por Sunbeam Products, Inc., Boca Raton, Florida 33431. ©2002 Sunbeam Products, Inc. Todos os direitos reservados. SUNBEAM ® e SPRAY MIST ® som marcas registradas de Sunbeam Products, Distribuido pela Sunbeam Products, 33431. P. N. 103683 MODEL/MODELEMODELO3945MODEL/MODELE MODELO 3945 Instruction Manual 15-MINUTE AUTO-OFF STEAM IRON READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE Manuel d’Instructions FER A VAPEUR AVEC SYSTEME D’ARRET AUTOMATIQUE APRES 15 MINUTES LIRE TOUTES LES INSTRUCTIONS AVANT D’UTILISER CET APPAREIL Manual de Instrucciones PLANCHA A VAPOR CON APAGADO AUTOMATICO DE 15 MINUTOS LEA TODAS LAS INSTRUCCIONES ANTES DE USAR ESTE APARATO Manual de Instrucoes FERRO DE VAPOR COM DESLIGADO AUTOMATICO DE 15 MINUTOS LEIA TODAS AS INSTRUCOES ANTES DE USAR ESTE APARELHO IMPORTANT SAFEGUARDS IMPORTANT SAFEGUARDS When using your iron, basic safety precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING 1. Use iron only for its intended use. 2. To protect against risk of electric shock, do not immerse the iron in water or other liquids. 3. The iron should always be turned to “OFF” before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect. 4. Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around iron when storing. 5. Always disconnect iron from electrical outlet when filling with water or emptying and when not in use. 6. Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron. Take it to a qualified serviceman for examination and repair. Incorrect reassembly can cause a risk of electric shock when the iron is used. 7. Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while connected or on an ironing board. 8. Burns can occur from touching hot metal parts, hot water or steam. when you turn a steam iron upside down – there may be hot water in 9. If the iron is not operating normally, disconnect from the power supply and contact your nearest authorized Sunbeam SPECIAL INSTRUCTIONS 1. To avoid a circuit overload, do not operate same circuit. 2. If an extension cord is absolutely a 10-ampere cord should be used. Cords rated for less amperage may the cord so that it cannot be pulled KNOW YOUR SUNBEAM ® STEAM/SPRAY/DRY IRON 11 6 2 5 1 9 10 7 8 4 1. Temperature Control Dial 2. Power Indicator/Reset Button 3. Cord Wrap Groove 4. Non-Stick Sole Plate; 21 Steam Vents 5. Water Window 6. SPRAY MIST ® Nozzle 7. Water Fill Opening 8. Steam On/Off Control 9. SPRAY MIST ® Trigger 10. Fabric Temperature Suggestions 11. Heel Rest 2 3 SAVE THESE INSTRUCTIONS F EAT U R E S • SPRAY MIST ® – Provides a fine spray mist for spot dampening. Trigger control. • Temperature Dial – Controls heat output of iron. Adjust dial according to ironing needs. For low temperatures, turn the dial to the first dot. For medium temperatures, turn the dial to second set of dots. For high temperatures, turn dial to third set of dots. (Refer to Ironing Guide for recommended settings). • Swivel Cord – Pivots up and down and is supported to prevent dragging on fabric. Flexible grommet protects the cord from fraying. • Soleplate – Has full-length button grooves for added convenience when ironing shirts and blouses. • Non-Stick Finish – The non-stick coating on the soleplate prevents sticking of fabrics and starch residue. • Sliding Water Reservoir Cover – Prevents dust and foreign matter from entering the water tank; stops any water spillage during ironing. • Cord Wrap – Provides quick, convenient cord storage. • Automatic Shut-Off – Shuts off iron after 15 minutes of operation. • Power Reset Button – Press to reset. AUTO-OFF FEATURE When the iron is plugged into a 120 V, AC electrical outlet, the steady red signal light signals the iron is on. If the iron is left standing for 15 minutes, the iron will The signal light extinguishes to indicate auto shut-off and will stay out until either reset or unplugged. To restart iron: To restart iron after it has shut itself off, please reset the red button. CAUTION: DO NOT USE THE AUTO SHUT-OFF FEATURE AS A SUBSTITUTE FOR TURNING OFF AND UNPLUGGING THE IRON BEFORE FIRST USE To ensure no stain is transferred to the fabric the first time you use the iron, it is advisable to flush the soleplate steam vents to remove any resid...