Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
3.
In the Command View TL Data Verification screen, click Start for the library.
The DV engine will re-scan the slots and drives assigned to the DVP partition and restart the
DV engine.
Enabling the use of unlabeled media
By default, the library requires that each tape cartridge have a proper bar code label and does
not detect unlabeled media.
Detection of unlabeled media can be enabled from the Configuration > System > Allow Unlabeled
Media screen.
Using unlabeled media can significantly increase the inventory scan time and is therefore not
recommended for normal operation.
Configuring OCP/RMI session locking
The library only supports one OCP or RMI user session at a time. By default, when a user logs into
the RMI or OCP, the existing user session is terminated.
When OCP/RMI Session Locking is enabled, a new session will not terminate the current session
and the new user will not be able to log in.
NOTE:
When this setting is enabled, always log out of the RMI or OCP when finished with a
session. Otherwise, no new sessions will be allowed until the current session times out.
Configuring the MSL Encryption token to remain logged in across library
reboots
By default the security user must provide the token password each time the library is powered on
or booted. When the Keep Token Logged In Across Reboots option is enabled the token password
is only required after the library has been powered off or encounters a hard shutdown. The password
is not required after a reboot. Access the Keep Token Logged In Across Reboots option from the
Configuration > Encryption > USB — MSL Encryption Kit screen.
Configuring a KMIP server that uses certificate-only authentication
Most KMIP servers use a client username and password along with the signed certificate for
authentication. Some KMIP servers only use the signed certificate. In the KMIP Wizard, the KMIP
Client Configuration screen provides options for these two types of server authentication.
•
If your KMIP server uses a client username and password for authentication, enter the username
and password that were specified on the KMIP management console for the library.
•
If your KMIP server uses only certificate passing for authentication, check Enable KMIP
Certificate-only authentication. Only select this option if you are using a KMIP server that
requires it and you do not have a client username and password.
SMTP security protocol changes
SSL 3.0 is disabled and TLS 1.2 is now supported in the SMTP configuration.
In the Configuration > Network Management > SMTP screen the security protocols for accessing
the server are now:
•
None
•
SSL/TLS
•
STARTTLS
Enabling the use of unlabeled media
5
...Эта инструкция также подходит к моделям:
Устройства обработки данных - HP MSL Tape Library (220.68 kb)
Устройства обработки данных - HP MSL2024 0-Drive Tape Library (220.68 kb)
Устройства обработки данных - HP MSL2024 1 LTO-4 Ultrium 1760 SAS Tape Library (220.68 kb)
Устройства обработки данных - HP MSL2024 1 LTO-4 Ultrium 1840 Fibre Channel Tape Library (220.68 kb)