Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
From the RMI:
Go to Operations > Magazines. Select Left, Right, or Both, and then
Replacing the tape cartridges and
click on Release. Pull the released magazine(s) out of the device. If
selecting Both, follow the instructions that display on the OCP.
magazine(s)
Transfer the tape cartridges from the old magazine(s) to the new
magazine(s) if necessary. Tapes may be pushed out of the slots by
pushing the tape through the hole on the back of the magazine.
IMPORTANT:
The clear plastic pieces in the magazine slots are required by
the robotics for slot alignment. Never remove these clear plastic
pieces.
Using the manual release:
Slide the magazine(s) completely into the device. The magazine(s) will
lock into place. The Library or Autoloader will re-inventory the
magazine(s) after the magazine(s) have been installed.
From the back of the device, determine which magazines need to be
removed. Number 1 will release all of the right magazines, Number 2
will release all of the left magazines.
The MSL4048, MSL8048, and MSL8096 Tape Libraries and their
mailslot-capable lower-left magazine have corresponding white dots on
1) the front bezel, and 2) the magazine. For mailslot capability, place
the magazine with the mailslot in the lower left magazine bay.
1) Insert a straightened paper clip or small metal pin about 1.5 cm (0.6
inch) into the appropriate magazine release hole, while 2) another
person grasps the magazines on that side and removes them from the
A magazine without mailslot capability, with a single mailslot, or with
Autoloader or Library.
three mailslots can be installed in the lower left magazine position. The
Library mailslot configuration will change if the new magazine is different
from the previously installed magazine.
IMPORTANT:
A mailslot magazine placed in a location other than the lower left
Do not force the pin once you encounter resistance. Doing so
magazine position will behave as a 12-slot magazine without a mailslot.
can damage the Autoloader or Library.
Getting help
• HP Product information:
nl
www.hp.com/products/tapestorage
• HP technical support and phone numbers:
nl
www.hp.com/support
• HP StorageWorks Library & Tape Tools (L&TT) diagnostic software:
nl
www.hp.com/support/tapetools
NOTE:
Use HP StorageWorks Library & Tape Tools to verify installations
and ensure that your device has the latest firmware.
Page 2
...Эта инструкция также подходит к моделям:
Устройства обработки данных - HP MSL Tape Library (215.25 kb)
Устройства обработки данных - HP MSL2024 0-Drive Tape Library (215.25 kb)
Устройства обработки данных - HP MSL2024 1 LTO-4 Ultrium 1760 SAS Tape Library (215.25 kb)
Устройства обработки данных - HP MSL2024 1 LTO-4 Ultrium 1840 Fibre Channel Tape Library (215.25 kb)