Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Configuring virtual disks from the host server
After you create and verify the virtual disks on the EVA3000/5000, and then rescan or restart the host
server, you must configure the new disk resources. See your host server documentation for instructions
on configuring disk resources.
The operating system treats an HSV110 virtual disk much like a SCSI disk. Therefore, you can use Logical
Volume Manager (LVM) commands pvcreate, vgcreate, and lvcreate to manually add the
virtual disk LUN to the host. The following is an example of manually adding a virtual disk LUN to the host:
• Create the physical volume on the virtual disk using pvcreate.
• Create the directory on the virtual disk using mkdir.
• Create the node on the virtual disk using mknod.
• Create the volume group on the virtual disk using vgcreate.
• Create the logical volume on the virtual disk using lvcreate
• Create a file system on the virtual disk.
• Mount the file system (to gain access to the virtual disk).
Creating volume groups on a virtual disk using vgcreate
Create a volume group on a virtual disk by issuing a vgcreate command. In order for HP-UX to access
the virtual disk, the vgcreate command builds the virtual group block data. In addition, refer to the
pvcreate, vgcreate, and lvcreate man pages for more information about creating disks and file
systems. Use the fol owing procedure to create a volume group on a virtual disk:
1. Create the physical volume on a virtual disk by entering a command similar to the following:
# pvcreate -f /dev/rdsk/c32t0d1
2. Create the volume group directory for a virtual disk by entering a command similar to the following:
# mkdir /dev/vg01
The designation vg01 is an example. Use a unique designation for each volume group you create.
3. Create the volume group node for a virtual disk, by entering a command similar to the following:
# mknod /dev/vg01/group c 64 0x010000
The designation 64 is the major number that equates to the 64–bit mode. The 0x01 is the minor
number in hex, which must be unique for each volume group.
4. Create the volume group for a virtual disk by entering a command similar to the following:
# vgcreate -L 1000 /dev/vg01/lvol1
5. Create the logical volume for a virtual disk by entering a command similar to the following:
# lvcreate -f /dev/vg01 /dev/dsk/c32t0d1
In this example, a 1-GB logical volume (lvol1) is created.
6. Create a file system for the new logical volume by creating a file system directory name and inserting
a mount tap entry into /etc/fstab.
7. Run mkfs on the new logical volume.
The new file system is ready to mount.
HP StorageWorks 3000/5000 Enterprise Virtual Array connectivity for HP-UX installation and reference
13
guide
...Эта инструкция также подходит к моделям:
Устройства обработки данных - HP StorageWorks EVA3000 EMEA Bundles (119.94 kb)