Оценок - 4, средний балл: 4.3
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Transponder: Selects a transponder from the list or adds a new transponder. DiSEqC Mode: Selects DiSEqC mode for the selected LNB. Lower LNB Oscillators: Sets the LNB oscillators to a lower frequency. Upper LNB Oscillators: Sets the LNB oscillators to a higher frequency. Tone 22 kHz: Selects the Tone 22 kHz depending on the LNB type. For a universal LNB it should be Auto. Signal Quality: Display the current status of broadcasting signal. . SatCR/Unicable Settings: Configure single cable installation. N This function may not support depending on the region. SatCR/Unicable: Enables or disable single cable installation support. Slot Number: Select the SatCR user slot number for this receiver. Slot Frequency: Enter the appropriate frequency to receive the signal from SatCR. Detect Slot Frequency: Auto-detect the signal frequency for the selected slot number. Verify Slot Frequency: Verify that the frequency entered corresponds to the selected slot. . Positioner Settings: Configures the aerial positioner. Positioner: Enables or disables the positioned control. Positioner Type: Sets the positioned type between DiSEqC 1.2 and USALS (Universal Satellite Automatic Location System). – My Longitude: Sets the longitude for my location. – My Latitude: Sets the latitude for my location. – Satellite Longitude Settings: Sets the longitude of user defined satellites. User Mode: Sets the position of satellite aerial according to each satellite. If you store the current position of satellite aerial according to a certain satellite, when the signal of that satellite is needed, the satellite aerial can be moved to pre-populated position. – Satellite: Selects the satellite to set the position for. – Transponder: Selects a transponder from the list for signal reception. – Moving Mode: Selects the movement mode between discrete and continuous movement. – Step Size: Adjusts the step size degrees for the aerial rotation. Step Size is available when Moving Mode is set to Step. – Go To Stored Position: Rotates the aerial to the stored satellite position. – Aerial Position: Adjusts and stores the aerial position for the selected satellite. – Store Current Position: Stores current position as the selected positioner limit. – Signal Quality: Display the current status of broadcasting signal. Installer Mode: Sets limits to the scope of movement of satellite aerial or reset the position. Generally, installation guide uses this function. – Limit Position: Selects the direction of the positioner Limit. – Aerial Position: Adjusts and stores the aerial position for the selected satellite. – Store Current Position: Stores the current position as the selected positioner Limit. – Go To Zero: Moves the aerial to the reference position. – Reset Positioner Limit: Allows the aerial to rotate over the full arc. . Reset All Settings: All satellite settings will be reset to the initial values. Changing the Preset Picture Mode Picture Mode Menu > Picture > Picture Mode Picture modes apply prese...
Эта инструкция также подходит к моделям:Телевизоры - UA32EH4030W (2.17 mb)
Телевизоры - UA32EH4500W (2.17 mb)
Телевизоры - UA32EH4530W (2.17 mb)
Телевизоры - UA32EH5300W (2.17 mb)