Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
Cable Connection Incoming Cable from Cable Company Connect the cable supplied by your local cable company. Tighten with fingers only. Use of any tool (e.g. pliers) for tightening may result in tuner damage. 75 Ohm VHF/UHF on back of TV Note: A cable converter box may be required for proper reception. Check with your local cable company for compatibility requirements. Antenna Connections • For proper reception of VHF/ Incoming Cable from Home Antenna UHF channels, an external antenna is required. For best reception an outdoor antenna is recommended. Note: Cable Mode is preset at the factory. Antenna users must change to TV Mode in the Set Up menu under Prog Chan. Remote Control Battery Installation Requires two AA batteries (supplied). Battery Polarity 1 AA/ 1.5A AA/ 1.5A 2 3 Procedure 1. Turn the remote control face down. Remove battery cover by pressing down on the marking on the cover and sliding it off in the direction indicated. 2. Install batteries matching (+) and (-) polarity signs. 3. Replace the battery cover by sliding in reverse until the lock snaps. Note: Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control. Precautions • Replace batteries in pair. • Do not mix battery types (zinc carbon with alkaline). • Do not recharge, heat, short-circuit, disassemble, or burn batteries. 4 • INITIAL SET UP MENU Initial Set Up Menu For your convenience, the Initial Set up menu will be displayed on screen when the set is turned on for the first time. If needed, follow the menus and procedures for setting up the features. IDIOMA/LANGUE To change menu language to ENGLISH, SPANISH or FRENCH. Procedure • Press VOL • to select English, Spanish or French. FIRST PLEASE CONNECT THE ANTENNA INITIAL SET UP IDIOMA/LANGUE ENGLISH • MODE CABLE • AUTO PROGRAM • PRESS ACTION TO EXIT MODE To select TV (antenna) or CABLE mode depending on the signal source. Procedure • Press VOL .. to select TV or CABLE. FIRST PLEASE CONNECT THE ANTENNA INITIAL SET UP IDIOMA/LANGUE ENGLISH • MODE CABLE • AUTO PROGRAM • PRESS ACTION TO EXIT AUTO PROGRAM To automatically program all available channels received through the RF input. Procedure • Press VOL .. to start Auto Programming. FIRST PLEASE CONNECT THE ANTENNA INITIAL SET UP IDIOMA/LANGUE ENGLISH • MODE CABLE • AUTO PROGRAM • PRESS ACTION TO EXIT ENGLISH 5 • OPTIONAL EQUIPMENT CONNECTIONS Optional Equipment Connections Note: The remote control must be programmed with supplied codes to operate the optional equipment (refer to page 9 for programming information). VCR Connection VCRs, video disc players, video game equipment, and DSS equipment can also be connected to the video inputs. See the optional equipment manual for more information. Note: VIDEO 1 input is a dual-purpose input. It is primarily intended for connection with 480i devices such as a DVD player using the Y PB PR component video jacks and Audio L & R jacks. However, it can also be connected to conventional composite video...
Эта инструкция также подходит к моделям:Телевизоры - CT32E14 (5.04 mb)
Телевизоры - CTG2134 (5.04 mb)
Телевизоры - CTG3354 (5.04 mb)
Телевизоры - CTG2174 (5.04 mb)