Оценок - 2, средний балл: 5
(
)
)
|
Фрагмент инструкции
WARNING! Do not use standard bulbs! These develop too much heat and may damage the machine! Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse. 1. Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.) 2. Replace defective bulb. 3. Screw cover back down. Check the correct positioning of o-ring gasket before screwing back the door light cover. Do not operate the dryer when missing o-ring gasket on door light cover. WARNING! For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated. SETTINGS 35 SETTINGS The special options that can be set under SETTINGS remain permanently stored independent of each drying cycle – even after the appliance has been switched off or the mains plug has been removed from the socket. To enter the settings: 1. Press OPTION button repeatedly until selection frame marks SETTINGS. 2. Press OK button to confirm. LENGUAGE CLOCK BRGHTNESS 12:05 SETTINGS 3. Use OPTION button to scroll through the list. After few seconds of inaction settings view comes back to main view. You can get back to previous view each time if you select Back and confirm OK. LANGUAGE Language setting is always first as a default. 1. Press OK button - frame above language abbreviation starts blinking. 2. Press OPTION button until you set requested language. 3. Press OK to confirm. TIME 1. Press OPTION button until TIME selected. 2. Press OK to confirm - hour indication starts blinking. 3. Press OPTION until you set the right hour. 4. Press OK to confirm - minutes indication starts blinking. 5. Press OPTION until you set right minutes. 6. Press OK to confirm. BRIGHTNESS 1. Press OPTION button until BRIGHTNESS selected. 2. Press OK to confirm - frame around bar indicator starts blinking. 3. Press OPTION until you set right brightness level. 4. Press OK to confirm. CONTRAST 1. Press OPTION button until CONTRAST selected. 2. Press OK to confirm - frame around bar indicator starts blinking. 3. Press OPTION until you set right contrast level. 4. Press OK to confirm. 36 36 SETTINGS WATER HARDNESS Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the water. 1. Press OPTION button until WATER HARDNESS selected. 2. Press OK to confirm - frame around bar indicator starts blinking. 3. Press OPTION until you set right hardness level. 4. Press OK to confirm. available selections: – -low conductivity <300 .S/cm – - medium conductivity 300-600 .S/cm – - high conductivity >600 .S/cm is set as default. FULL TANK WARNING - ON/OFF The container indicator at the end of the programme can be deactivated, for example, if an external condensed water drain is installed. 1. Press OPTION button until FULL TANK WARNING selected. 2. Press OK to confirm - frame around bar indicator starts blinking. 3. Press OPTION until you set right status. 4. Press OK to confirm. Warning is set to ON as default. Technical data 37 Technical data This appliance conforms with the following EU Directives: – 2006/95/EC dated 12.12.2006 Low Voltage Directive – 89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC – 93/68/EEC dated 22.07.1993 CE Marking Directive Height x width x depth 85 x 60 x 58 cm Drum volume 108 l Depth with loading door open 109 cm Height can be adjusted by 1.5 cm Weight when empty approx. 48 kg Loading volume (depends on programme)1) max. 7 kg Voltage 230-240 V Required fuse 13 A Total power 2350 W Energy efficiency class B Energy consumption (7 kg of cotton, pre- drained at 1000 rpm) 2) 3.92 kWh Average annual energy consumption 284.1 kWh Use Domestic Permissible ambient temperature + 5°C to + 35°C Consumption values The consumption values have been established under standard conditions. They may deviate when the machine is operated in domestic circumstances. Programme Energy consumption in kWh / average dry- ing time in min. COTTON CUPBOARD DRY 2) 3) 3.92 / 125 (7 kg load pre-drained at 1000 rpm) 3,75 (7 kg load pre-drained at 1200 rpm) 3,60 (7 kg load pre-drained at 1400 rpm) 3,20 (7 kg load pre-drained at 1800 rpm) COTTON IRON DRY 2) 3.34 / 107 (7 kg load pre-drained at 1000 rpm) SYNTHETICS CUPBOARD DRY 2) 1.33 / 48 (3 kg load pre-drained at 1200 rpm) 1) Different loading volume data may be needed in some countries as a result of different measuring methods. 2) in accordance with EN 61121 Hints for test institutes Parameters possible to be checked by the Test Institutes: • Energy consumption (corrected with final h...
Эта инструкция также подходит к моделям:Сушильные машины - 88840 (2.38 mb)
Сушильные машины - 88840 (2.38 mb)
Сушильные машины - 88840 (2.38 mb)