Wear protective hair covering to contain long hair. 9. USE SAFETY GLASSES. Wear safety glasses or goggles while operating power tools. Also face or dust mask if operation creates dust. All persons in the area where power tools are being operated should also wear safety glasses and face or dust mask. 10. DON’T ABUSE CORD. Never carry tool by cord or yank it to disconnect from receptacle. Keep cord from heat, oil, and sharp edges. Have damaged or worn power cord and strain reliever replaced imme

Switching on the device: j Press the ON / OFF switch or “II“. 2 into setting “I“ Switching off the device: j Press the ON / OFF switch 2 into setting “0“. adjusting the air quantity and temperature: You can use the temperature and air quantity control 2 to set two different blower levels. It is therefore possible to select the appropriate quantity of air and temperature in accordance with the intended use: Setting I 300 l / min 350 °C Setting II 500 l / min 550 °C GB/IE/CY Operation / Cleaning U

Before reading, unfold the page containing the illustrations and familiarise yourself with all functions of the device. Przed przeczytaniem prosze rozlozyc strone z ilustracjami, a nastepnie prosze zapoznac sie z wszystkimi funkcjami urzadzenia. Olvasas elott kattintson az abrat tartalmazo oldalra es vegezetul ismerje meg a keszulek mindegyik funkciojat. Pred branjem stran s slikami odprite navzven in se nato seznanite z vsemi funkcijami naprave. Pred ctenim si otevrete stranu s obrazky a potom

Icon Description Purpose 20 . Cone nozzle Welding, shrink sleeving (heat concentrated over small area) 50 mm Fish tail Drying, thawing surface nozzle (heat spread over wide area) 1. Make sure the on/off switch (A) is in position "O" and the is disconnected from the power source. Ensure the nozzle cooled down. 2. Place the desired accessory onto the nozzle. 6 OPERATION WARNING: Make sure the nozzle ALWAYS points away from you and any bystanders. WARNING: DO NOT drop anything into the nozzle. WARN

WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: Do not connect to power supply until assembly iscomplete. Failure to comply could result in accidental starting and possible serious personal injury. OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless