Table 3 HP-UX 11i v3 September 2009 Fixes — IEther-00 B.11.31.0909
SR Number
Description
QXCR1000915759
The iether driver is enhanced to log the Producer and the Consumer index of the Receive
ring under following conditions:
• When the HP-UX system panics
• When the HP-UX system is TOC'd
QXCR1000910543
The HPVM host system encounters a panic in the iether driver transmit path. This panic
occurs during the execution of certain scripts when network traffic is going through a Virtual
NIC configured using AVIO_LAN over APA vSwitch. The APA port used for the vSwitch
is configured over iether network interface ports. The following scripts are affected:
• hplm stop
• hpapa stop
• hpapa start
• hplm start
QXCR1000909009
Network packets transmitted are dropped in the HPVM guest OS, which causes a drop in
throughput rate. This occurs when network traffic is going through a Virtual NIC which is
configured using AVIO_LAN over APA vSwitch. The APA port used for the vSwitch is
configured over iether network interface ports.
Two independent problems contribute to the packets being dropped. One problem is resolved
by the iether driver in this release. The other is resolved in the B.11.31.0909 version of the
AVIO HostAvioLan hssn driver (CR :QXCR1000929012).
Table 4 HP-UX 11i v3 October 2008 Fixes — IEther-00 B.11.31.0810
SR Number
Description
QXCR1000854397
On fiber cards with IEther-00 version B.11.23.0809 installed, performing any of the following
actions might cause a LINK DOWN condition that persists until the system reboots:
• Executing two or more resets with lanadmin -r.
• Performing multiple disable/enable cycles on the switch ports.
• Disconnecting and reconnecting the cabling.
Table 5 HP-UX 11i v3 September 2008 Fixes — IEther-00 B.11.31.0809
Reference Number
Description
QXCR1000771417
NC364m card port link flaps when the interconnect bay is empty.
4 Known Problems and Limitations
No known problems were identified for this version of IEther-00 at the time of this publication.
5 Compatibility and Installation Requirements
This section describes the compatibility information and installation requirements for this release.
•
For specific installation instructions, see the installation procedure or overview document
for your card.
•
For detailed information on supported server platforms, operating systems, and firmware
level requirements, see the Ethernet Support Matrix.
These documents are available at:
http://docs.hp.com/en/netcom.html
5.1 Operating System and Version Compatibility
This release is specific for HP-UX 11i v3 (B.11.31).
4

---

...

Эта инструкция также подходит к моделям:
Сетевое оборудование - HP-UX 11i v3 I/O Cards (178.51 kb)