Войти:
Сортировка : Названию ↑   Загрузкам   Оценке   Размеру ↑  
Скачали: 0   Размер: 56 kb   Производитель: American Standard  
Категория: Сантехника
@name

e 06091000 Oil Rubbed Bronze 06091620 Brushed Nickel 06091820 Polished Nickel 06091830 Rubbed Bronze 06091920 The measurements shown are for reference only. Products and specifications shown are subject to change without notice. Specification sheet revised 1/2009

Скачали: 0   Размер: 169 kb   Производитель: American Standard  
Категория: Сантехника
@name

FINISHED WALL 79mm(7-1/8) 13mm (1/2) 23mm (7/8) C/L OF SEAT POST HOLES 140mm (5-1/2) CTR'S. 305mm (12) C/L C/L OF SUPPLY AS REQUIRED FINISHED FLOOR 176mm (7) 736mm (29) 473mm (18-1/2) 140mm(5-1/2)203mm (8) 343mm (13-1/2) 305mm (12) 384mm (15) 767mm (30-1/4) 388mm (15-5/16) 413mm (16-1/4) 355mm (14) 6 7 INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions. 8a 8bBefore continuing, determine the type of water supply connecation you have from the chart below and use t

Скачали: 0   Размер: 160 kb   Производитель: American Standard  
Категория: Сантехника
@name@name@name

Instructions d'installation Installation Instructions ADVERTENCIA: Cierre la tuberia de la ali mentacion del agua caliente y fria antes de comenzar lainstalacion INSTALACION DE LA LLAVE Instale la llave (1) sobre el lavabo. (No es necesario sellar a menos que la cubierta de montaje en el lavabo no este uniforme). ATTENTION Fermer l'alimentation d'eau chaude et froide avant de commencer. Installer le ROBINET (1) sur le lavabo. (Aucun scellant n'est requis sauf si la surface du lavabo est inegale)

Скачали: 0   Размер: 369 kb   Производитель: American Standard  
Категория: Сантехника

Unthread HANDLE BASE (1) from DECK ADAPTER (2). Pull HANDLE ASSEMBLY off VALVE STEM (3). Remove SPRING CLIP (4). Lift STOP WASHER (5), turn 90° and replace. Replace SPRING CLIP (4). Find correct position of HANDLE ASSEMBLY by adjusting male teeth on VALVE STEM (3) to female teeth in HANDLE. Thread HANDLE ASSEMBLY onto DECK ADAPTER (2) until snug against mounting surface. 4 3 5 HANDLE ASSEMBLY REMOVE HANDLE 1 2 4 5 3 BOTTOM SPLINE END UP Push ADAPTER (1) on VALVE STEM (2), so that the hole of the

Скачали: 10   Размер: 69 kb   Производитель: American Standard  
Категория: Сантехника

Скачали: 8   Размер: 69 kb   Производитель: American Standard  
Категория: Сантехника

Скачали: 0   Размер: 369 kb   Производитель: American Standard  
Категория: Сантехника
@name

Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of right VALVE using appropriate connector. VALVE ASSEMBLY HOT COLD 12 4 13 7 6 8a 8 5 13 12 3 4 MOUNTING SURFACE Thread of VALVE BODY (4) should extend at least 5/16 inch above MOUNTING SURFACE (11). If necessary, adjust LOCKNUT (1). 10 9 9 M965027 REV.1.6 Wrench 4 INSTALL HANDLES 5 SERVICE 2 90° To change direction of handle rotation, proceed as follows: Turn valve to OFF position. Unthread HANDLE BASE (1) from DECK

Скачали: 2   Размер: 2 mb   Производитель: American Standard  
Категория: Сантехника
@name

In Massachusetts, the maximum output temperature of the shower mixing valve can be no higher than 112.F. Recommended tools (not included) grease pencil or other marking tool level ruler 2 & 3 mm Allen wrenches 6 mm drill bit 8 mm wrench Philips screwdriver waterproof sealant ............................................................ 8 mm 2 mm 3 mm 6 mm Installation Drill the screw holes with a 6 mm bit. Install the anchors. If both ends of the showerpipe are mounted on tile, install the top an

Скачали: 1   Размер: 70 kb   Производитель: American Standard  
Категория: Сантехника
@name

OR C.W.T. SUPPLY AS REQUIRED TO FLUSH VALVE 330mm (13") 19mm (3/4") 142mm (5-1/4") 83mm (3-1/4") 62mm (2-1/8") 1-1/2" SPUD C/L 229mm (9) FINISHED WALL 470mm (18-1/2") C/L OF SEAT POST HOLES 140mm(5-1/2") CENTERS 660mm (26") 133mm (5-1/4") 191mm (7-1/2") 298mm (11-3/4") (4) 22mm (7/8") DIA. HOLES 356mm (14") C/L OF OUTLET FINISHED FLOOR 32mm (1-1/4") 330mm (13") (3/4") 19mm 133mm(5-1/4" ) 83mm (3-1/4") C/L 229mm (9") 38mm (1-1/2") DIA. HOLE IN WALL 95mm (3-3/4") FOR WALLS UP TO 1" IN THICKNESS FO

Скачали: 0   Размер: 140 kb   Производитель: American Standard  
Категория: Сантехника

Go to our website at for more solutions to toilet problems. © 2001 Fluidmaster, Inc. ® Registered trademark of Fluidmaster, Inc. Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster shall not be responsible or liable for any damages caused by products used with Fluidmaster valves that were not manufactured by Fluidmaster, Inc. 30800 Rancho Viejo Road San Juan Capistrano, CA 92675 (949) 728-2000 (800) 631-2011 LIFT ARM FIRST 7301102-100 Rev. K - 3 RE





Категории