Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Integrating Data Protector
A. Instal ing a Media Agent
You can either install the General Media Agent or the NDMP Media Agent on systems that will be physically
connected to a backup drive in a StorageTek library and on the system that will access the library robotics
through the ACSLS.
Note: You need special licenses, depending on the size of the repository with media or the number of drives and
slots used in the StorageTek library. For more information, see the HP Data Protector Installation and Licensing
Guide.
Prerequisites
• The StorageTek library has to be configured and running. For details of configuring a StorageTek library, see
the documentation that comes with the StorageTek library.
• You need the following information before you start installing the Media Agent software:
– The hostname of the host where ACSLS is running.
– A list of ACS drive IDs that you want to use with Data Protector. Log in on the host where ACSLS is running
and execute the following command to display the list:
rlogin "ACSLS hostname" -l acssa
Enter the terminal type and wait for the command prompt. At the ACSSA prompt, enter the following
command:
ACSSA> query drive all
The format specification of an ACS drive has to be the fol owing:
ACS DRIVE: ID:#,#,#,# - (ACS num, LSM num, PANEL, DRIVE)
– Make sure that the drives that will be used for Data Protector are in the online state. If a drive is not in the
online state, change the state with the following command on the ACSLS host:
vary drive drive_id online
– A list of available ACS CAP IDs and ACS CAP format specification. Log in on the host where ACSLS is
running and execute the following command to display the list:
rlogin "ACSLS hostname" -l acssa
Enter the terminal type and wait for the command prompt. At the ACSSA prompt, enter the following
command:
ACSSA> query cap all
The format specification of an ACS CAP has to be the fol owing:
ACS CAP: ID:#,#,# (ACS num, LSM num, CAP num)
– Make sure that the CAPs that will be used for Data Protector are in the state online and in the manual
operating mode.
If a CAP is not in the state online, change the state using the fol owing command:
vary cap cap_id online
If a CAP is not in the manual operating mode, change the mode using the fol owing command:
set cap manual cap_id
– On Windows systems: A list of SCSI addresses for the drives, for example, scsi4:0:1:0.
– On UNIX systems: A list of UNIX device files for the drives.
Run the ioscan -fn system command on your system to display the required information.
Steps
1. Distribute a Media Agent component to clients using the Data Protector GUI and Instal ation Server for
Windows.
2. Start the ACS ssi daemon on all library hosts with access to the robotics on the library.
On Windows clients:
Instal the LibAt ach service. Refer to the ACS documentation for details. Make sure that during the
configuration of the LibAt ach service you enter the appropriate ACSLS hostname. After a successful
10
...Эта инструкция также подходит к моделям:
Программное обеспечение - HP Data Protector V6.10 Software (412.76 kb)
Программное обеспечение - HP Data Protector V6.11 Software (412.76 kb)
Программное обеспечение - HP Data Protector v6.20 English SW E-Media (412.76 kb)
Программное обеспечение - HP Data Protector v6.20 French SW E-Media (412.76 kb)