Patient Alarm A Graham-Field Brand Patient Alarm For Bed and Chair • Alarm includes ON/OFF switch and dual volumes. • Audio alarm sounds when patient gets out of chair or bed • Uses one 9v battery (included). • Six month limited warranty. GF13605 Patient Alarm for Wheelchair Pad Size 10"x15" GF13606 Patient Alarm for Bed Pad size 11"x30" 1 ea 1 ea Patient Alarm With Pull Cord • Attaches to bed/chair with self contained clip. • Audio alarm sounds when pin connector is pulled from the

ne 9V battery (included). • One year limited warranty. GF13602 Patient Alarm with Pull Cord, Small 1 ea GF13602 O- Vi- Patient Alarm with Magnetic Pull Cord • Attached to bed/chair with self contained clip and adjustable cord. • Audio alarm sounds with magnetic pull switch is removed. • Includes ON/OFF switch and dual volumes. • Uses two AAA batteries (included). • One year limited warranty. Graham-Field Health Products 2935 Northeast Parkway Atlanta,Georgia 30360 2006 © Graham-Fie

Turn the T-Handle clockwise until the screw is seated in the dimple on the cylinder valve. Be sure the regulator is tightened securely into the cylinder. • Attach the oxygen supply tubing to the outlet connection of the regulator. Set-Up (H-Nut Style) • Inspect the cylinder following the instructions of your gas supplier. Be sure to purge the cylinder valve seat of debris. • Inspect the regulator for oil or grease. If either is visible, DO NOT use the regulator. • Before attaching the regul

In addition, some models may be used in emergency situations. In an emergency situation, be sure to contact a physician or EMS immediately. 4 WARNING: DO NOT reuse plastic crush gaskets (fire risk). Set-Up (Yoke Style) • Inspect the cylinder following the instructions of your gas supplier. Be sure to purge the cylinder valve seat of debris. • Inspect the regulator for oil or grease. If either is visible, DO NOT use the regulator. • Be sure the sealing washer is in place on the inlet of the r

In addition, some models may be used in emergency situations. In an emergency situation, be sure to contact a physician or EMS immediately. 4 WARNING: DO NOT reuse plastic crush gaskets (fire risk). Set-Up (Yoke Style) • Inspect the cylinder following the instructions of your gas supplier. Be sure to purge the cylinder valve seat of debris. • Inspect the regulator for oil or grease. If either is visible, DO NOT use the regulator. • Be sure the sealing washer is in place on the inlet of the r

Turn the cylinder off and turn the regulator on to relieve any built-up pressure. Try tightening the regulator to the cylinder and opening the cylinder again. If this does not help, shut the system down again and contact a service representative. NEVER attempt to repair a regulator or cylinder yourself. • Adjust the flow rate setting by turning the knob clockwise until the desired setting shows in the window. • If the cylinder pressure falls below 300 PSI, exchange the cylinder for a full one.

Lifting the patient from a bed 1. With patient face-up in center of bed, roll patient onto their side away from attendant. 2. Place sling, folded lengthwise, halfway under patient with lower edge just beneath knees. 3. Roll patient onto their side toward attendant, pull sling to smooth it, and center patient on sling. 4. Pull the leg loops forward and under the thighs. 5. Cross the loops, one through the other. 6. Roll the patient lift under the bed, locating the spreader bar over the patient. B

Contact your Lumex dealer for a new cylinder. LF1040 ELECTRIC PATIENT LIFT SYMPTOM POSSIBLE CAUSE ACTION Control box is not responding and relay is notclicking Battery discharged Charge battery Battery charger defective Replace battery charger Battery defective Replace battery Hand control defective Replace hand control Actuator does not run, butrelay is clicking Actuator plug not properly seated Push actuator plug firmly into control box Actuator defective Replace actuator Control box defective

Weight Capacity..............................................600 lb Floor Clearance........................................................5.75" Lifting Range Min. Height.........................................27.0" Max. Height..............................................................71.0" Overall Length..........................................................50.0" Overall Width............................................................26.2" Max. Base Width..........................