Оценок - 3, средний балл: 3.7 ( )

Производитель: Southbend Размер: 533.21 kb Название файла: Язык инструкции:

The proper gas line pressure is 5-7" W.C. for natural gas and 11-14" W.C. for propane. 8. Remove manometer fitting and replace plug in manifold. 9. Replace front panel. 10. Turn on main gas to appliance and light pilots. ADJUSTMENT OF PILOT FLAME (GRIDDLE MODELS) The pilots are adjusted at the factory. If later the pilots are over-adjusted to the point where the flame is leaving its port, or “blowing off,” the result is an unstable condition in which the pilot may extinguish. If necessary, adjust each burner’s pilot using the following procedure: 1. Open the door on the lower front of the appliance, remove the control knobs, and remove the control panel by removing the screws holding it in place. 2. If necessary, light the pilots. 3. Locate the adjustment valve of the pilot that needs adjustment (see Figure 7 below). On thermostatic griddles, the valve is in the pilot’s supply line, while on manual griddles the valve connects the pilot’s supply line to the front manifold. Turn the pilot adjustment screw to the left to increase the size of the pilot flame, or to the right to decrease the size of the pilot flame. The flame should be about 1/2" high with a slight yellow tip, and cover the thermocouple tip. The flame is too high if the yellow tip is producing black streaks of carbon. 4. Repeat Step 3 for each pilot. 5. Replace the control panel and knobs. Figure 7 PilotFlame Adjustment Screwon Thermostatic GriddlesPilotFlame Adjustment Screwon Manual Griddles ADJUSTMENT OF PILOT FLAME (CHARBROILER AND OPEN-TOP MODELS) The pilots are adjusted at the factory. If later the pilots are over-adjusted to the point where the flame is leaving its port, or “blowing off,” the result is an unstable condition in which the pilot may extinguish. If necessary, adjust each burner’s pilot using the following procedure: 1. If necessary, light the pilots. 2. Locate the pilot adjustment valve (see Figure 8 below). Turn the pilot adjustment screw to the left to increase the size of the pilot flame, or to the right to decrease the size of the pilot flame. The flame should be about 1/2" high with a slight yellow tip. The maximum pilot flame height is 3/4". The flame is too high if the yellow tip is producing black streaks of carbon. 4. Repeat Step 3 for each pilot. 5. Replace the control panel and knobs. Figure 8 PilotFlameAdjustmentScrews ADJUSTMENT OF BURNER FLAME The burners are adjusted at the factory. If necessary to adjust the burner flames, do the following for each burner: 1. Turn the burner’s control knob to the full ON position. 2. If the appliance was cold, wait 5 minutes before adjusting the burner flame. 3. Loosen the set screw that holds the sheet-metal air shutter in place. 4. If the burner flame is blowing or lifting off the burner ports, close the air shutter until a stable flame is obtained. If the flame is yellow-tipping, open the air shutter until a stable blue flame is obtained (a small amount of yellow-tipping is normal when using propane gas). 5. Tigh...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: