Оценок - 3, средний балл: 4.3 ( )

Производитель: Southbend Размер: 533.21 kb Название файла: Язык инструкции:

Obtain the instructions from the local gas supplier. ! CAUTION To eliminate gas build up which could result in an explosion, in the event of main burner ignition failure a five minute purge period must be observed prior to re-establishing ignition source. ! CAUTION Top section pilots, when out, do not interrupt the flow of gas to the burners. Consequently, it is the responsibility of the operator to check the ignition of the burners, immediately after burner value has been turned “ON.” Should ignition fail after 10 seconds, turn off burners, wait 5 minutes, and then try again. ! WARNING UNDER NO CIRCUMSTANCES IS A GRIDDLE TO BE USED FOR HEATING STOCK POTS. SUCH USE AUTOMATICALLY VOIDS THE WARRANTY. NEVER COOL A GRIDDLE BY APPLYING ICE OR WATER TO THE GRIDDLE SURFACE. DAMAGE DUE TO MISUSE IS NOT COVERED BY THE WARRANTY. DO NOT STRIKE A GRIDDLE SURFACE WITH THE EDGE OF COOKING IMPLEMENTS TO CLEAN THE IMPLEMENTS. SUCH ACTION WILL CUT AND PIT THE GRIDDLE PLATE, LEAVING IT ROUGH AND HARD TO CLEAN. ALWAYS HEAT A GRIDDLE SLOWLY. DO NOT HEAT A GRIDDLE ABOVE 550°F. LIGHTING AFTER GAS HAS BEEN SHUT OFF When turning the main gas supply on after the gas supply has been shut off, do the following: 1. Make sure all of the control valves are in the “OFF” position. 2. Turn on the gas supply. 3. Light the pilots as described in each section below. OPERATION OF THERMOSTATIC GRIDDLE MODELS Each 12"-wide griddle section has a thermostatic-control knob on the front panel that directly controls the flow of gas, and so the heat. Turn the knob clockwise to increase the heat; turn it counterclockwise to reduce the heat. The griddle requires approximately 13 minutes of preheating to reach 350°F, and 45 minutes to even out. Do not waste gas or abuse equipment by leaving control knobs set at a high temperature if not required. During idle periods, set control knobs to low temperature settings to keep griddle warm. After each period of use, allow the griddle surface to cool normally. At the end of each day’s use, turn all control knobs to the “OFF” position. After the griddle has cooled, coat the griddle surface with a light film of cooking oil to protect the surface from moisture. To shut down the appliance for an extended period (or before disconnecting the gas supply), turn all the burner control gas knobs “OFF,” then turn the main gas supply valve(s) to “OFF.” To light the pilots of a thermostatic griddle section, do the following: 1. Turn all griddle controls to the “OFF” position. ON 2. Open the grease/control door at the bottom of the front of the griddle. OR ATI3. Turn the main shut-off valve to the “ON” position (if it is not already ON). (Note that 60" and 72" models have two shut-off values, one in each burner compartment.) P4. Note that the left pilot must be lit before the right pilot can be lit. For each pilot, press and hold the red pilot button and light the pilot by pressing the electronic ignition button on the front panel to generate a spark. Continue to h...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: