Part No. Part Description Comments Revision dwg21221 Drawing Image Number 815-143C RH DISC BRAKE ASM 172mm W/JNT (S/N 400270+) Does not include #3, Rev. 2 #4 & #5 700-256D RH DISC BRAKE ASM 1/6 TAPER (S/N 400269-) Does not include #3, Rev. 1 #4 & #5 815-144C LH DISC BRAKE ASM 172mm W/JNT (S/N 400270+) Does not include #3, Rev. 2 #4 & #5 700-257D LH DISC BRAKE ASM 1/6 TAPER (S/N 400269-) Does not include #3, Rev. 1 #4 & #5 1. 802-589C HHCS 7/16-14X2 GR5 2. 803-229C NUT HEX FLANGE LOC 7/16-14 PLT

5. 710-097D KEY 3/16 X 3 6. 790-001A TREKER ENGINE/TRANS ALIGNMENT Optional 7. 800-235C SPRING CLAMP 1" OD HOSE 8. 800-259C CLAMP WRM DRV#36SS (1.81-2.75) 9. 800-350C KEY .187 X .247 X 2.5 LG 10. 801-180C TPHMS Y 1/4-20X3/4 YELLOW DIE 11. 801-197C HSFHCS 5/16-24 X 3/4, BLK 12. 801-199C SCR SELF TAP #10 X 3/4 13. 802-005C HHCS 1/4-20X1 GR5 14. 802-320C HHCS 1/2-20X2 GR5 15. 802-738C HHCS 5/16-18X1 GR5 YELLOW DIE 16. 802-770C HHCS 3/8-24X3 1/2 GR5 PLT 17. N/A INSERT, 1/4-20 ARS4-420-280 Included w

MAIN WIRING HARNESS NT (S/N 418339 to 440713) Rev. 2 not compat. w/Rev. 1 833-260C10. WIRING HARNESS TRUCK (S/N 418338-) N/A11. BATTERY BCI Group U1/U1R, min. 300CCA. See Note 1 833-277C12. TAILLIGHT Includes bulb 833-335C13. WIRE HARNESS INSTRUMENT PANEL (S/N 418339+) Rev. 2 not compat. w/Rev. 1 833-296C13. WIRING HARNESS INSTRUMENT PANL (S/N 418338-) 833-303C14. 20" 6GA NEGATIVE BLACK CABLE 833-338C15. 30 AMP RESETABLE CIRUIT BREAKR 839-288C16. 20 AMP FUSE (5 PACK) 840-105C17. PUSH RETAINERS 4

Your life and the lives of others depend on it! © Copyright 2009 Printed 02/19/09 Cover photo may show optional equipment not supplied with standard unit. Table of Contents Part Number Index Section 1: Introduction.................................................4 Using This Manual...............................................................4 Manual Replacement Information.......................................4 Manual Revisions................................................................4

25, 27, 29, 31, 61, 81, 89 802-005C ...................25, 39, 61 802-010C ...................19, 89 802-017C ...................43 100 4210ST & 4410ST Utility Vehicles Treker 700-109P 02/19/09 Table of Contents Part Number Index Part Number Index (continued) Part Number Page Part Number Page 802-024C ...................41 802-078C ...................85 802-079C ...................19 802-080C ...................73, 75 802-113C ...................41 802-115C ...................43, 77 802-138C ...

If the battery is dead, see Using A Booster Battery (Jump Starting) on page 52. 3. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Chock the wheels. 4. Gasoline vehicles: Prepare the fuel tank. 4.1. Fill the tank with fresh fuel. 4.2. Following the manufacturer’s directions, add a commercially available fuel stabilizer (such as Sta-Bil®). Run the engine in a well-ventilated area to allow treated fuel to replace untreated fuel in the carb

LUBRICATION CHANGE FOR FRONT DIFFERENTIAL, TRANSMISSION, AND REAR DIFFERENTIAL Use the lower plug (2) for drainage (Figure 30, Figure 31, or Figure 32). Remove both plugs to allow the lubricant to drain faster. See preceding NOTE. Metal particles may be discovered in the fluid or on the magnetic drain plug when changing the differential or transmission fluid. These particles are normal and expected for the first few fluid changes. This is a result of the gears being “net forged”, meaning the gea

Never install tires of differentdiameters on the vehicle. • Reduced steering control can occur when the front differential is locked. STOPPING THE VEHICLE To stop the vehicle, release the accelerator pedal and press the brake pedal until the vehicle comes to a complete stop. See following WARNING and CAUTION. WARNING • Driving through water may affect the brakes. After driving through water, check effectiveness of thebrakes by gently pressing the brake pedal. If the vehicle does not slow down at

8 Proposition 65 – State of California........................................................................................................................ 8 Safety Details....................................................................................................................................................... 9 General Warnings............................................................................................................................................... 10 General

• The vehicle is not specially equipped for handicapped persons: – Be sure all passengers are capable of securing themselves in a moving vehicle before allowingthem to ride in one. – Be sure all persons can properly operate the vehicle prior to allowing them to drive the vehicle. • Stop the vehicle before shifting the Forward/Reverse handle. Engine must be at idle before shiftingthe Forward/Reverse handle. Failure to do so may result in injury to inattentive passengers and(or) damage to the vehi