Оценок - 5, средний балл: 3.6
(
)
)
|
Фрагмент инструкции
If the battery is dead, see Using A Booster Battery (Jump Starting) on page 52. 3. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Chock the wheels. 4. Gasoline vehicles: Prepare the fuel tank. 4.1. Fill the tank with fresh fuel. 4.2. Following the manufacturer’s directions, add a commercially available fuel stabilizer (such as Sta-Bil®). Run the engine in a well-ventilated area to allow treated fuel to replace untreated fuel in the carburetor. 4.3. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 34). 4.4. Plug the fuel tank vent nipple so that it is air tight. Husqvarna recommends using a slip-on vinyl cap. 5. Remove both spark plugs, and pour 1/2 ounce (14.2 mL) of SAE 10 weight oil through each of the two spark plug holes. Rotate the engine crankshaft by hand several times, then install both spark plugs. 6. Diesel vehicles: If Biodiesel fuel is used, see Biodiesel Fuel (Diesel Vehicles Only) on page 48. Prepare the fuel tank. 6.1. Fill the fuel tank with fresh fuel. 6.2. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 35). 6.3. Plug the fuel tank vent nipple so that it is air tight. Husqvarna recommends using a slip-on vinyl cap. 7. All vehicles: Change engine oil. See Engine Oil and Filter Change on page 40. HUV 4421 Owner’s Manual Page 31 Maintenance 8. Disconnect battery and spark plug (Gas only) wires. See Disconnecting the Battery – Gasoline/Diesel Vehicle on page 13. 9. The battery should be clean and free of corrosion. Wash the battery top and terminals with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3.8 L) of water). Rinse the solution off the battery. Do not allow this solution to enter the battery. Be sure the terminals are tight. Let the terminals dry and then coat them with Battery Terminal Protector Spray (P/N 603 00 00-03). 10. Adjust the tires to the recommended tire pressure. See Vehicle Specifications on page 56. 11. Perform semiannual periodic lubrication. See Periodic Lubrication Schedule on page 36. 12. Thoroughly clean the front body, rear body, seats, cargo bed, engine compartment, and underside of vehicle. 13. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling. RETURNING THE STORED VEHICLE TO SERVICE 1. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Chock the wheels. 2. Restore the fuel system to operation (Figure 34 or Figure 35). 2.1. Remove the plug from the fuel tank vent. 2.2. Connect the vent tube to the fuel tank vent. 3. Connect battery and spark plug (Gas only) wires. See Connecting the Battery – Gasoline/Diesel Vehicle on page 13. Coat terminals with Battery Terminal Protector Spray (CCI P/N 1014305). 4. Gasoline vehicles only: Completely open the fuel shut-off valve (Figure 14). Ensure the valve is fully open. A partially closed fuel shut-off valve combined with the use of the choke can result in a fouled spark plug and engine failure. 5. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into the carburetor (gasoline vehicles) and the fuel lines (all vehicles) and the engine starts. Turn the engine off. See following NOTE. NOTE: Due to the oil added to the gasoline engine in preparation for storage, the engine may smoke excessively for a short time when it is run for the first time after storage. 6. Perform the Pre-Operation and Daily Safety Checklist on page 22 and the Performance Inspection on page 23. MAINTENANCE See General Warnings on page 11. To ensure trouble-free vehicle performance, follow an established preventive maintenance program. Regular and consistent maintenance can prevent vehicle downtime and expensive repairs. Use the Pre-Operation and Daily Safety Checklist on page 22, the Performance Inspection on page 23, and the following Periodic Service Schedule and Periodic Lubrication Schedule to keep the vehicle in proper working condition. Any vehicle not functioning correctly should not be used until it is properly repaired. This will prevent further damage to the vehicle and help prevent injury to occupants resulting from unsafe conditions. Contact your local dealer/distributor for repairs and semiannual and annual periodic service. WARNING • Only trained technicians should service or repair the vehicle. Anyone doing even simple repairs orservice should have knowledge and experience in electrical and mechanical repair. The appropriateinstructions must be used when performing maintenance, service, or accessory installation. WARNING CONTINUED ON NEXT PAGE Page 32 HUV 4421 Owner’s Manual Periodic Service Schedule WARNING • If any problems are found during scheduled inspection or service, do not operate vehicle until repairsare made. Failure to make necessary repairs could result in fire, property damage, severe personalinjury, or death. • Do not wear loose clothing or jewelry such as rings,...
Эта инструкция также подходит к моделям:Оборудование к ТС - HUV 4421 4421-D/DX/DXL (5.03 mb)