Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
1 docking doors 1 docking doors with spring 2 longer post Back to Contents Page Back to Contents Page Fan Dell™ Latitude™ D500 Service Manual 1. Follow the instructions in "Preparing to Work Inside the Computer." 2. Remove the keyboard. 3. Remove the palm rest. 4. Remove the microprocessor thermal-cooling assembly. 5. Pull straight up on the fan cable connector to disconnect it from the system board connector. 6. Remove the two M2.5 x 8-mm screws from the fan, and pull the fan away from the system board. Back to Contents Page CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer. 1 M2.5 x 8-mm screws (2) 2 fan 3 fan cable connector 4 system board connector Back to Contents Page Hard Drive Dell™ Latitude™ D500 Service Manual 1. Follow the instructions in "Preparing to Work Inside the Computer." 2. Turn the computer over. Use a standard #1 Phillips screwdriver to remove the M2.5 x 5-mm screw. 3. Open the display approximately 0.5 inch. 4. Slide the hard drive out of the computer. 5. Remove the new drive from its packaging. Save the original packaging to use when storing or shipping the hard drive. CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive. CAUTION: Before working inside your computer, read the safety instructions in your System Information Guide. NOTICE: To prevent data loss, shut down your computerbefore removing the hard drive. Do not remove the hard drive while the computer is on, in standby mode, or in hibernate mode. NOTICE: Hard drives are extremely fragile; even a slight bump can damage the drive. NOTE: Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell. 1 M2.5 x 5-mm screw NOTICE: If you do not open the display before you remove your hard drive, you might permanently scratch your display. NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting Against Electrostatic Discharge" in your System Information Guide. 6. Open the display approximately 0.5 inch. 7. Press the hard drive cover down until it is fully seated in the bay, and tighten the screw. 8. Use the Operating System CD to install the operating system for your computer. 9. Use the Drivers and Utilities CD to install the drivers and utilities for your computer. Back to Contents Page NOTICE: If you do not open the display before you replace your hard drive, you might permanently scratch your display bezel. NOTICE: Use firm and even pressure to slide the drive into place. If you force the hard drive into place using excessive force, you may damage the connector. Back to Contents Page Keyboard Dell™ Latitude™ D500 Service Manual 1. Follow the instructions in "Preparing to Work Inside the Computer." 2. Turn the computer top-side up and open it. 3. Remove the center control cover: a. Open the display all the way (180 degrees) so that it lies flat against your work surface. b. Starting on the right side of the computer, use a plastic scribe to pry up the center control cover. Lift it away from the computer, and lay it aside. CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer. 1 display 2 center control cover 3 palm rest 4. Remove the keyboard: a. Remove the two M2.5 x 6-mm screws across the top of the keyboard. b. Rotate the keyboard up and slide it forward. c. Hold the keyboard up and slightly forward to allow access to the keyboard connector. d. Pull up on the keyboard connector tab to disconnect the keyboard connector from the system board. Back to Contents Page 1 center control cover NOTICE: The keycaps on the keyboard are fragile, easily dislodged, and time-consuming to replace. Be careful when removing and handling the keyboard. 1 M2.5 x 6-mm screws (2) 2 keyboard tabs 3 palm rest NOTE: When you replace the keyboard, ensure that the keyboard tabs are completely in place to avoid scratching the palm rest. Back to Contents Page Base Latch Dell™ Latitude™ D500 Service Manual 1. Follow the instructions in "Preparing to Work Inside the Computer." 2. Remove the hard drive. 3. Remove the keyboard. 4. Remove the display assembly. 5. Remove the palm rest. 6. Remove the speakers. 7. Pull the base latch straight up and away from the computer base. Back to Contents Page CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or ...