Оценок - 4, средний балл: 3.8
(
)
)
|
Фрагмент инструкции
If using a screen saver, set it to the active screen mode. Do not use a damaged or loose plug. • This may cause an electric shock or fire. Do not pull the plug out by the wire nor touch the plug with wet hands. • This may cause an electric shock or fire. Use only a properly grounded plug and receptacle. • An improper ground may cause electric shock or equipment damage. Do not excessively bend the plug and wire nor place heavy objects uponthem, which could cause damage. • This may cause an electric shock or fire. Do not connect too many extension cords or plugs to an outlet. • This may cause fire. Installation Be sure to contact an authorized service center, when installing your monitor in a location with the heavy dust, high or low temperatures, high humidity, chemical substance and where it operates for 24 hours such as the airport, the train station or etc. Failure to do so may cause a serious damage to your monitor. Put your monitor in a location with low humidity and a minimum of dust. • Failure to do so may cause an electric shock or fire inside the monitor. Do not drop the monitor when moving it. • This may cause damage to the product or human body. Install the monitor base in a showcase or shelf so that the end of the base does not project beyond the showcase or shelf. • Dropping the product may cause damage to the product or personal injury. Set down the monitor carefully. • The monitor could be damaged or broken. Do not place the monitor face down. • The TFT-LCD surface may be damaged. Installing a wall bracket must be done by a qualified professional. • Installation by unqualified personnel may result in injury. • Always use the mounting device specified in the owner's manual. Install the product keeping a distance of 10 cm from the wall for ventilation purposes. • An overheated product may catch fire. Clean When cleaning the monitor case or the surface of the TFT-LCD screen, wipe with a slightly moistened, soft fabric. Do not spray water or detergent directly on the monitor. • This may cause damage, electric shock or fire. Use the recommended detergent with a smooth cloth. If the connector between the plug and the pin is dusty or dirty, clean it properly with a dry cloth. • A dirty connector can cause an electric shock or fire. Contact the Service Center or Customer Center for interior cleaning once a year. • Keep the product's interior clean. Dust which has accumulated in the interior over an extended period of time may cause malfunction or fire. Other Do not remove cover (or back). No user serviceable parts inside. • This may cause an electric shock or fire. • Refer servicing to qualified service personnel. If your monitor does not operate normally - in particular, if there are any unusual sounds or smells coming from it - unplug it immediately and contact an authorized dealer or service. • This may cause an electric shock or fire. Be careful not to let water drip into the monitor or expose the monitor to moisture. • This may cause malfunction, an electric shock or fire. • Especially avoid operating the monitor near water or outdoors where it could be exposed to snow or rain. If the monitor is dropped or the casing is damaged, turn the monitor off and unplug the power cord. • The monitor may malfunction, causing an electric shock or fire. • Then contact the Service Center . Disconnect the plug from the outlet during storms or lightening or if it isnot used for a long period of time. • Failure to do so may cause an electric shock or fire. Do not try to move the monitor by pulling only the wire or the signal cable. • This may cause a breakdown, electric shock or fire due to damage to the cable. Do not move the monitor right or left by pulling only the wire or thesignal cable. • This may cause a breakdown, electric shock or fire due to damage to the cable. Do not cover the vents on the monitor cabinet. • Bad ventilation may cause a breakdown or fire. Do not place water containers, chemical products or small metal objects on the monitor. • This may cause malfunction, an electric shock or fire. • If a foreign substance enters the monitor, unplug the power cord and contact the Service Center . Do not use or store inflammable substances near the monitor. • This may cause an explosion or fire. Never insert anything metallic into the monitor openings. • This may cause an electric shock, fire or injury. Do not insert metal objects such as chopsticks, wire and gimlet orinflammable objects such as paper and match into the vent, headphoneport or AV ports. • It may cause a fire or an electric shock. If an alien substances or water flows into the product, turn the product off, unplug the power connector from the wall outlet and contact service center. If you view a fixed screen for an extended period of time, residual imageor blurriness may appear. • Change the mode to energy save or set a screensaver to moving picture when you need to be away from the monitor for an extended period of time. Adjust the resolu...
Эта инструкция также подходит к моделям:Мониторы - 915N (4.87 mb)