A backguard should be ordered at the same time as the range. Both must be on site at the time of installation. Order one backguard for 48" models: ZX1B48WSS-1-1/2" high backguard (required for island installations) ZX12B48WSS-12" high backguard ZX22B48WSS-22" high backguard with warming rack (2 piece) Advance Planning: Refer to dimensional drawings for appropriate placement and necessary clearances when planning the installation. • Cabinetry cannot be installed directly above the range. •

1350436 DATED 06-15-2006 To learn more about DELTA MACHINERY visit our web To learn more about BIESEMEYER MANUFACTURING site at: For Parts, Service, visit our web site at: For Parts, Warranty or other assistance, please call 1-800-223-7278 Service, Warranty or other assistance, please call 1-800-782-1831 INTRODUCTION The BIESEMEYER® T-SQUARE® Blade Guard System is designed for use on most table saws. The table mount is designed for use on saws equipped with the BIESEMEYER® T-SQUARE® Saw Fence sy

8 and 9, since we are mounting the splitter to a 10” Left tilting Arbor Unisaw. NOTE: Just snug up button head screws at this time. 9. Using a straight edge (R) Fig. 10, align the top portion of splitter mounting bracket (P) to saw arbor (S) as shown. Then tighten two screws (N) Fig. 9. 5 Fig. 8 K L M N P Q Q N P Fig. 9 R P S Fig. 10 10. Insert index pin (T) Fig. 11, through the hole in splitter (U), as shown, and fasten with locknut (V). Fig 11 illustrates the index pin assembly arrangement for

• Avoid prolonged contact with sawdust from treated lumber. Do not allow dust to get into your mouth, eyes or lay on the skin. Wear protective clothing whenever possible. • The label on your tool may include the following symbols. V ................volts A ..................amperes Hz ..............hertz W..................watts min..............minutes ................alternating current ............direct current no ................no load speed ................Class IIConstruction ...........

b. Align the arrow on the housing wdith the line on the shoe Fig. 7. c. Rotate the shoe to the desired angle. After setting the shoe, tighten it by returning the shoe lever to its oringinal position. NOTE: The shoe will be difficult to bevel at first. Ensure the shoe lever is up and the two arrows shown are aligned. Gently rock the shoe from side to side to loosen. At 0°, the shoe may slide back to allow for cutting in tight work areas. Lift the shoe lever, slide the shoe back and depress the le

DW788/383329 8/6/02 10:35 AM Page 3 English IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY DEWALT TOOL, CALL US TOLL FREE AT: 1-800-4-DEWALT (1-800-433-9258) WARNING: FOR YOUR OWN SAFETY, READ INSTRUCTION MANUAL BEFORE OPERATING SAW • DO NOT WEAR GLOVES, NECKTIES, JEWELRY OR LOOSE CLOTHING • CONTAIN LONG HAIR • ALWAYS WEAR EYE PROTECTION • INSTALL BLADE WITH TEETH POINTING DOWNWARD TOWARD THE TABLE BEFORE OPERATING SAW • MAINTAIN PROPER ADJUSTMENT OF BLADE TENSION BLADE GUARD BEFORE OPE

Orbital action has a more aggressive blade motion and is designed for cutting in soft materials like wood or plastic. Orbital action provides a faster cut, but with a less smooth cut across the material. In orbital action, the blade moves forward during the cutting stroke in addition to the up and down motion. NOTE: Metal or hardwoods should never be cut in orbital action. To adjust the cutting action, move the cutting action lever (G) between the four cutting positions: 0, 1, 2, and 3. Position