Tool, Inc, 714 W, Grant 602-624-5248 Tucson 05719 Western Tool Inc, 702 So Campbell 602-804-0504 ARKANSAS Ft Smilh 72901 Tool Service Co, 4420 Wheeler Avenue 501-648-3125 Little Rock 72202 Eleclric Tool Service 1419 Wesl 10th Slreet 501-374-8180 CALIFORNIA City ol Industry 91745 Porter-Cable Corporalion 1305 John Reed Court 818-333-3566 Concord 94520-5679 California Electric Service 1170-G Burnell Avenue 415-827-1011 Fax: 415-827-5409 Covina 91723-3536 California Eleclric Service 61

DEPTH OF CUT ADJUSTMENT The jointer can be set to cut any depth from a very thin shaving to 1/8" deep. A dual English/Metric scale (A) Fig. 24, and pointer (B) are provided to indicate the depth of cut. To adjust for depth of cut, loosen lock knob (C) and turn adjusting knob (D) clockwise to lower and counterclockwise to raise the infeed table. After the infeed table is at the desired setting, tighten lock knob (C). NOTE: For best results, final positioning of the infeed table should always be m

35, and squeeze locking lever (C), and raise or lower handle (B). 3. NOTE: When raising or lowering the infeed table, a depth stop (D) Figs. 35 and 36, will automatically stop the table at an 1/8" depth-of-cut. To move the table past this point, the depth stop must be lifted as shown, and the table can be moved up or down. Always make sure table lock handle (A) Fig. 34, is tightened before operation. The table lock handle (A) is spring-loaded and can be repositioned by pulling out the handle and

Delta may require that electric motors be returned prepaid to a motor manufacturer’s authorized station for inspection and repair or replacement. Delta will not be responsible for any asserted defect which has resulted from normal wear, misuse, abuse or repair or alteration made or specifically authorized by anyone other than an authorized Delta service facility or representative. Under no circumstances will Delta be liable for incidental or consequential damages resulting from defective product